Leupold Recent Questions, Troubleshooting Help & Support

Try orion.com

Of hand, I would have you check to see if the sensor is covered by dust or dirt or condensation.

This general scope manual has a short section and points back to Leupold.com for more info. http://www.leupold.com/wp-content/uploads/2012/07/Tactical_Scope_Manual.pdf Here is a video: www.youtube.com/watch?v=574_o76Nf94

Telephone 1-800-Leupold 1-800-538-7653 Shipping Address Leupold & Stevens 14400 NW Greenbrier Parkway Beaverton, OR 97006-5790

Go to the Remington Firearms Co. website. At the top of the page, click on Support, then click on Owners manuals. They list the Remington model 12 as one of the one's they have. It will be a photo copy of the original owners manual.

Go to Numrich/Gunparts Corp., they have a parts schematic for your Remington 582.

No, it means the retical (cross hairs) will move 1/4 in. at 100yds.for every click of the windage or elevation knob.

There should be an arrow indicating direction on the windage adjustment turret (normally the right side) of the scope. If the arrow is marked left, turn the adjustment knob the other way to move the zero right. To move the bullet point of impact right, move the adjustment knob (dial) right.

I found that mine works great if I do not over tighten the cap on the battery. back it off little by little until it does work.

www.leupold.com/.../rangefinders/rx-rangefinders

This problem is caused by the 'step' inside the battery cover which prohibits the tip of the battery from contacting the nipple inside the cover. I fitted a thin piece of aluminium strip (20thou) and the rangefinder works perfectly now. Make sure you dont bridge-out the +ve to the neutral (i.e. battery casing).

This problem is caused by the 'step' inside the battery cover which prohibits the tip of the battery from contacting the nipple inside the cover. I fitted a thin piece of aluminium strip (20thou) and the rangefinder now works perfectly. Most brands of CR2 battery now have higher sides which shield the tip - bad design.

cut sections of beer can the same size as the mount. Shims go between the mount and the receiver. NEVER inside the rings.

I have purchase one Nightforce BR Benchrest 12-42X56 NP2 DD Riflescope C107 last week from a new ecommerce website exclusively for Nightforce products. I would recommend to get advice from their support team who are hunters themselves.