Our 131 faucet leaking from under the cover, is it defective?
if this is installed in a small rv , wow I know all about the problem with these , seems this type of pump allows one to draw water from a storage tank on board and the user provides the "power" via moving the handle up/down to draw up the water , but then when in the park you can connect fresh park water to faucet and using the same handle in opposite direction pressurized water flows out of it , first thing , its in a rv !! if inside air temp is not maintained 24/7 365 between 35F and 210F it plastic its gonna crack (mine did) and I don't know about you but my rv is outta my mind in the off season so no temp is being maintained inside it , if this is what happened then just replace it , no glue will hold up to its use ! second parks water pressures vary so carry your own water pressure regulator and use it between park and your rv ! these things only handle about 40 psi and then they crack open , and last but not least invest in some food grade rv antifreeze this is great stuff to "put up" the rv for the off season run it thru everything that gets water into it saves you tons on replacing things in the spring time
8/26/2015 2:54:15 AM •
Leisure...
•
Answered
on Aug 26, 2015
•
425 views
Febo Electric Fireplace Insert Using remote It
Maybe its the fireplace's ignition spark box at the bottom of the fireplace, its behind the bottom vents and bought one on line and replaced it, easy as pie. Best of luck
3/7/2015 4:14:09 AM •
Leisure...
•
Answered
on Mar 07, 2015
•
865 views
My electric fireplace don't work,I
I took the fireplace's direct connect ignition spark box out of the bottom of the fireplace, its behind the bottom vents and bought one on line and replaced it, easy as pie. Best of luck
3/7/2015 4:12:51 AM •
Leisure...
•
Answered
on Mar 07, 2015
•
240 views
What is the comparison of heating 1500 cu. ft. to 1000 sq. ft.?
a cubic foot is a 12inch by 12inch square by 12inch depth its like stacking 1500 little sq. boxes in a room or two.a 12ft by12ft room with 8ft walls would hold 1152 cubic feet or little boxes.so in comparison 1500cu ft is little more than one room,1000sqft is a small house.
2/22/2015 3:59:53 AM •
Leisure...
•
Answered
on Feb 22, 2015
•
194 views
Marco gas firplace
I have a Model 792864B. Before you attempt to light the pilot light - make sure that any wall control switch or remote control for the fireplace is in the off position. Locate the gas supply line. There should be a gas supply valve to turn on the gas supply. The valve is usually painted a different color than the supply line like blue, green or yellow. Open the valve by pivoting the handle to be parallel to the gas line, usually counter-clockwise. When it is closed it is at a 90 degree angle from the supply line. Locate the pilot light assembly - this is the pilot light. There should also be a red or black ignitor button and a black or green valve control knob with the words "on" "off" and "pilot" on it. It may be located inside a black box, mine is marked heatolator, that has a lift off top. Lift off the top of the box. Push in the valve control knob and turn it until the word "pilot" is in line with the arrow (my arrow is red) or indicator line. While pressing and holding in the valve control knob - it presses in about 1/4", press the red or black ignitor button repeatedly (once per second) until the pilot ignites. Once the pilot is lit, continue to hold the valve knob in for about 30 seconds and then slowly release. The pilot should remain lit. If it remains lit, press in and turn the valve control knob to the "on" position. The on/off wall or remote control switch should now light your fireplace. If the pilot doesn't ignite, turn off gas supply valve, wait about 5 minutes and try it again.
11/2/2014 9:04:55 PM •
Leisure...
•
Answered
on Nov 02, 2014
•
20,425 views
Not emping water
This is a generalize answer, but remove the bottom kick panel to manually rotate the pump motor. In general they can get locked up by objects. Locking up the pump.
Glass lid?
These are tricky, first remove all burners trivets knobs etc so there is nothing at all left on the glass top then you will need two small screwdrivers gently using them like tyre levers work around the edge and it will usually just lift off, when replacing it make sure that everything is lined up properly.
5/8/2014 12:39:50 AM •
Leisure...
•
Answered
on May 08, 2014
•
313 views
Can ignight but when button is released flame goes out?
you have a problem with security valve you can find a small pin next to the ignition candle, make sure that this pin is close to the fire when pressing the button, this pin needs to heat to generate a low voltage to the valve in order to keep providing gas.
3/24/2014 9:47:00 PM •
Leisure...
•
Answered
on Mar 24, 2014
•
524 views
Serial code
Sorry, but "software piracy" is not allowed on FIXYA.
Purchase a legitimate copy of the software.
3/14/2014 6:14:28 AM •
Leisure City...
•
Answered
on Mar 14, 2014
•
45 views
Not finding what you are looking for?