Leeson Tools & Hardware - Others - Page 8 - Recent Questions, Troubleshooting & Support
How do I unjam my bostich T6-8 stapler and my old model T5-8 tacker?
How to Unjam a Bostitch Stapler
- Disconnect the construction stapler from the air supply. Use a hammer and punch to do this. ...
- Push the driver upwards and past the jammed staple. Do this by putting the punch at the tip of the driver, which you should see coming out of the nose. ...
- Tap the hammer against the punch and the jam should clear.
https://homeguides.sfgate.com/how-to-unjam-a-bostitch-stapler-13401638.html
Do you need to oil a bostitch 1850BN brad nail gun
All air tools need regular, sparing application of tool oil to maintain the seals and minimize moisture damage. With the tool disconnected from the air line, drip one or two drops of air tool oil -- NOT motor oil or any solvent -- into the air connector. Position the tool so the air connector is up, allowing the oil to run down into the tool.
My PaperPro One finger 15 sheet power Stapler just stopped stapling. ???
For PaperPro Prodigy. Best stapler I have used but after about 8 years the flat steel staple driver broke. To repair, remove the bottom by forcing it back, force the stapler halves apart with a flat screw driver and the top comes off. The springs and levers are on one half and they will not fly apart. I couldn't find the staple driver part (on the left) so go to the store and buy a new stapler.
Drying out wet drywall
I'm assuming your talking about drywall that was wet during a flood of some type? Recommend you remove all damaged drywall and using a straight edge and a utility knife this can be easily accomplished. After you cut and remove the damage, remove all screws or nails from the studs giving a good surface for the new drywall that your going to replace the damaged stuff with. Get that done and we can move onto taping and drywall compound repairs. Hope this helps.
Can’t get staple to come out
Didnt give much info to go on lol. Make /model and a little more detail on your issue will be needed before anyone can try to help you
How do you load a Arrowv nail master 2 et200 brad nail gun?
LOADING NAILS
* Disconnect the tool from the power source when loading brad nails * Tilt the tool or lay the tool flat, so the nails will not drop out while loading
*Press lever (A) while pulling slider (B) backwards Place the nail strip into magazine (C) (maximum capacity 100 nails)
Not finding what you are looking for?