Leeson Tools & Hardware - Others - Recent Questions, Troubleshooting & Support


check input voltage check to see if its the proper phase check tension on belts, gear, or connection from motor

Leeson... | Answered on Mar 05, 2015


If it has 9 leads and is a 240/480 volt motor the 1and 7 go to line 1. the 2 and 8 leads go to line 2 and the 3 and 9 leads go to line 3. the 4 5 and 6 leads are hooked together with a wire nut. To reverse rotation simply reverse any 2 of the line leads.. Prairie Dog........

Leeson... | Answered on Nov 15, 2012


It will not run. With only one wire hooked to both leads there is no potential and no place for the current to flow to. electric bruno.

Leeson... | Answered on Jun 17, 2011


It depends on what type of account, but if this is your credit card, call the 800 number on the card and report an erroneos charge, they will ask you a series of questions, like, have you contacted the business that has charged your card and tried to reslove it with them. If this is a bank account or checking account you need to conact your bank, you will most likely not get any money back if it was taken from your checking or debit card account. that why it is best to always use a major credit card.

Leeson... | Answered on Mar 23, 2011


03623x01.png


Here is a diagram the contactor needs a 120Volt supply & switch too.

Leeson... | Answered on Feb 15, 2010


it is possible that the start/run winding is open cicuit or cable connections via the capacitor you mentioned , is it distorted , any sign or leakage . as it is on a stair lift the motor has to be reversed , is the reversing switch intact.

Ian c

Leeson... | Answered on Jan 27, 2010


should be a wiring diagram on the wiring cover.

Leeson... | Answered on Oct 26, 2009


MOTOR SHOULD HAVE A RESET BUTTON.
IF U CAN FIND IT, HOLD IT IN-IF MOTOR RUNS
RESET MAY HAVE TO BE REPLACED.MAKE
SURE MOTOR DOES NOT OVERHEAT UNDER
LOAD-THIS MIGHT BE THE PROBLEM.

Leeson... | Answered on Jun 21, 2009


Hello Robert, you can find that tool in stores like Lowes, I sent you a link about it; specifically, this model is not available in the market, maybe you can find it in web pages, such as Craigslist. https://www.lowes.com/pl/Drill-presses-Presses-lathes-Power-tools-Tools/4294607825

Tools & Hardware... | Answered 3 days ago


Check incoming voltage umder load. if its under nameplate volts when running you have overcurrent. check fan inside housing for damage or blockage. finally check disch pressure to make sure no restriction blockage in line. Im Pentair engineering person

Tools & Hardware... | Answered 3 days ago


HI. I think I have the same problem. I cannot loosen the collet nut on my 5142 router to change the bit. The router is super powerful and great for a router table but since I got it years ago, changing the bits has been difficult. Might try the heat but worry it could effect bearings and grease etc.

Tools & Hardware... | Answered on May 16, 2019

Not finding what you are looking for?
Leeson Logo

14 questions posted

Ask a Question

Usually answered in minutes!

Top Leeson Tools & Hardware - Others Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Brad Brown

Level 3 Expert

18060 Answers

john h

Level 3 Expert

20200 Answers

Are you a Leeson Tool and Hardware - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...