Lasonic Recent Questions, Troubleshooting Help & Support

http://www.google.com/search?hl=en&q=Cassette+Drive+Belts Don't click: 6.anxijdt.com/16 link
http://www.wjoe.com/vintageandantiques.htm
http://www.studiosoundelectronics.com/cassette.htm
http://www.vintage-electronics.cc/
http://www.ceitron.com/passive/belt.html
http://www.ceitron.com/passive/passive.html
http://www.ceitron.com/order.html
http://www.metacafe.com/watch/1267468/how_to_fix_your_pioneer_cassette_deck/
http://www.fixya.com/support/t102401-cassette_player
http://www.google.com/products?hl=en&q=Cassette+Deck+Belts&um=1&ie=UTF-8&sa=X&oi=product_result_group&resnum=4&ct=title
http://www.ehow.com/how_114068_troubleshoot-cassette-deck.html
http://www.fixitclub.com/Electronics/Cassette_Deck.shtml
http://www.turntableneedles.com/index.asp

same happened to me. it might be the battery circuit or the batteries many times fall out of place so they dnt work. call lasonic or send it back for a new one for free like mine

okay, i had a similar problem, and the problem turned out to be a bad connection. If you open up the battery box, in the bottom top left corner there is a positive connection wire that looks kind of like a "U".
this connection doesn't come in contact with the batteries, so you need to extend it by wrapping a small piece of wire or something to make it stick out more.

what we actually did was put a piece of 1/4 in. by 1 in. piece of copper flashing in the plastic slot and across the U shaped connector to increase conductivity and it works fine.

i hope this was helpful!

That is a dirty pot switch.. The volume adjusting pot gets dirty.. Two things to try..

1.) With the unit off - spinn the volume min to max many many times at a rapid pace.. This sometimes will displace the debris in the pot..

If that does not work --

2.) Get some "tuner cleaner" in a spray can.. At Radio Shack or a similar store.. Lay the radio on its back so the volume knob is facing up.. Pull the knob off carefully.. Use short controlled bursts of the spray.. A few sprays and spin the knob min to max several times and repeat..

Good luck..

PLease dont forget to rate for your free question..

A Lasonic 931 ? It has probably been taken apart by someone before you and may have unplugged the power feed from the battery compartment. Remove the rear panel then check the two wires that come from the battery box are connected to the circuit board.If not, then check to see where they go on the board, it`s not hard to do.Look for the little tabs they slide onto..

You're getting that message because you've likely tried to open a card reader that has no media card in it. If you're sure that you're trying to open the right removable drive, right click on it and click explore, and it should open right up. I've gotten the same error when trying to load files to my flash drive from time to time. Hope this helps! www.dfwsupergeek.com

Are the batteries fully charged or show the charging status when you try to charge them? Are you able to turn it on with the external power supply? Also try replacing the batteries, they might be dead.

Happened to me, and a very common problem. on the top left of the battery compartment, there is a U shaped connector meant to hook up with the + battery on that side. it's too low, so the circuit doesnt complete. Use some aluminum foil or copper wire to make the U connect with that battery and it should work.

Are there any scratches on the cd? If there aren't. then you might want to bring in your dvd player to the service that you recieved it from and get it fixed.

I want some drivers
for it

You have a ATSC Digital tuner in your set which accepts over the AIR digital transmission. Your set does not have the ATSC QAM tuner to receive digital cable transmission. Those size sets are usually designed for outdoor use with an antenna and for camping ect.....Outside of that, go ahead and connect it and see what happens...Do auto program.

You hold the pause/play button in.

my media player wont take in downloads

try getting an universal remote it come with a code book and you should be able to program it to work with your dvd player

if you have the correct mains adapter yes.

the best way is to download realplayer. after you download it, it wil tell you what to do from there.

Take it back.

The player needed to be re-sync'd and now works - thanks