Clean ID Sensors
Are you looking for how to clean the TD sensor???? I'm not sure what a ID sensor is??? The TD sensor is above the transfer belt unit. You will have to remove the 4 drums & transfer unit and clean the inside area of the copier. Good Luck
How do I erase the tapes on a Lanier VW-210
Press the telephone button first with one finger and immediately after you press that button press the rewind button, The unit should go into rewind and erase should be flashing on the digital display. When the unit starts rewinding take your finger off of both buttons, if you keep them on ,then the unit will rewind and stop erasing .
Lanier 5227 scanner error
Eenter in the service mode press yellow key - 107 - red key(stop) keep press for 5 seconds,enter in the SP mode open the front door,turn OFF the main switch,wait 15 seconds close the front door,turn ON the power switch.
Lanier 5618 Network
Hi, Lanier 5618 is not a Network Copier. However, it may be installed on one PC and shared from there.
Drivers are available from LANIER Official SupportHope it helps! Good Luck! Thanks for using Fixya!CreativeTECH
Cannot connect to lanier printer/copier
Ours Lanier 5618 has a network adapter , finally succeeded to setup via it by : "add printer wizard" , after choosing 'Standard TCP/IP Port' ; we choose " Ricoh Generic Network Printer " instead of "Generic Network Card" at 'Dvice Type' .......
Lanier LD032
Hi Dwayne:This error occurs when performing the white level detection. Check: a - The white board on whether or not this position b - Glass and Optical c - UBS Card - (card may be faulty) d - BICU Card (may be faulty) e - Check the optics and connectors to the cards. I have heard that several times after cleaning the mirrors of the scanner worked.Hope this helps; also keep in mind that your feedback is important and I'll appreciate
your time and consideration if you leave some testimonial comment about
this answer.Thank you for using Fixya, and have a nice day.
I have a Lanier Transcriber
This unit most likely has a broken rewind/fast forward rubber belt. This is a very common problem and is easily fixed if you can acquire a new belt. Any place that services Lanier equipment should be able to easily fix this problem.
Lanier 5622 says following output tray is full
Hello!
Why did you change the fotoconductor Unit???? This part of the machine is to create the image.
Your problem is in the tray. Meaby a broken switch. Take out the all tray and look inside to see if there is same obstruction.
If you do not see anything i advise you to call a Tech.
Dont waste more money if you dont know what your doing. This is the best advise i can give you.
See you!
Hi have a lanier copier
Hello!
If you say that you see old ghodt copies the problem is with the Fuser Roller in the Fusing Unit.
If this is right i advise you to call a Tech (if you do not have the skills to change it)
See you!
I have a lanier ld425c
Hello!
I am not 100% sure but i think you can calibrate your touch panel.
Follow this steps:
- Press yellow key.
- On the key pad press 1999.
- Press Red Key five times.
After that you will see the option to calibrate your panel. You just need to follow the wizard.
If you have any dought reply to me.
See you!
Not finding what you are looking for?