Lanier Popular Questions, Answers, Tips & Manuals

Tape players need maintenance often. You have to replace the belt, clean the rubber roller with Rubber Renue, put grease on the odd spot and clean the head by rubbing clean white paper on it. Any electrical contacts like a volume switch etc need a contact spray to remove oxides etc. This should be done every 5 years or even more often if used more often.

Fuser error code Push clear modes 1 0 7 then hold stop for 5 seconds

This problem is referred to as color to color alignment. Most color laser systems have a rough adjustment by means of a screw somewhere and a fine adjustment that is done in diagnostic mode as part of a setup routine. Try the latter first by locating your manual and looking through the troubleshooting guide which should explain how to force the machine to do an automatic color alignment. Your manual should be available online from your manufacturer's web site if you can't locate it. If this doesn't work you will need to take it in for servicing unless you are handy with tools and can find a service guide for your model.

THIS IS FUSER UNIT

Bad toner pump

Fuser pressure error, service call

Did you try postscript driver from the Lanier website?

This is just a shot in the dark, but if there is no "reset" button, you might try unplugging it for a couple of minutes and it should reset itself. Just a guess. If you have an owners manual, I would check there to find how to solve this problem, but this may indicate the print heads are damaged in that area. You might enter the "menu" if there is one, and run any maintenance tools available to see if that corrects the problem. If you don't have an owner's manual, you might be able to find one at the printer manufacturer's website in the support section. This would give you a better idea if the problem was a do-it-yourself fix or whether you will need technical help.

Deleting a Registered NameThis section describes how to delete a name.

1. Press [System Settings].
2. [Administrator Tools>.
3. Press [Address Book Management].
4. Press [Delete].
5. Select the name you want to delete.Press the name key, or enter the registered number using the number keys.
6. Press [OK].
7. Press [Exit].
8. Press the [User Tools/Counter] key.

If you want to record somebody 3-4 feet from you then use the dictate mode. If you want to pick up voices in a large room then use the conference mode, it increases the microphone sensitivity to the maximum level.

user is: adminpassword is: password for new model password is empty

Please more detailes refer to problem.

Please the copier model for help you.

Reset with SP code 5810-1 ( clear modes 1 0 7 hold stop for 5 seconds)

run the CLEAN mode.orRemove the toner cartidge and clean the rollers.This happens when you use cheap paper. The dust gets on the roller drum and grays or streeks the copies

The boys at the office figured out how to get out and empty... Thanks for all your input... I had sent it on to them.

here are the causes of high CO:Defective Oxygen Sensor- Inoperative Air Injection System (if equipped)- Leaking or defective Fuel Injectors- Restricted air filter (especially if high CO is present only at high RPM)- Vacuum leaks resulting in improper MAP sensor operation- Defective air mass or air flow sensor- Malfunctioning fuel evaporation system or purge valve- Defective Catalytic Converter- Defective thermostat (cooling system), thermostat stuck open- Oil contaminated with fuel, excessive miles between oil changesSince this is not injected, you can rule that out.

Simply touch the desired tray on the touchscreen before copying.

Clean the **** glass. It is a long skinny glass to the left of the big rectangular glass under the feeder. Clean it and your problem should go away.

Look under the front of the unit and there is a tel ans switch this must be on to enable the unit to answer the call