Lanier Popular Questions, Answers, Tips & Manuals

Laser sync error, bad mirror motor?

you may need a new washer in the tap

Metal tab on right side of copier is bent and correctly touching the duplex unit interlock switch. Open the duplexer and notice the metal tab stick out. Put back to a 90 degree angle.

Open the front door, lift the clam shell open and carefully replace or empty the white used toner container. Replace and turn the blue knob clockwise a few times.

select manually on the panel.

No bottle, it is inside the transfer belt unit that hangs on the inside of the right hand door. Dump it and put it back.

The error code is not related to the toner. What model?

Depends on the associate engine code. Most of the time it means that maintenance is overdue. Otherwise, it is an electronic issue.

Try neutral if it doesn't start there then your lever and P R N D L are out of sync. You could also try pulling the little plug out of you consul and pushing down with a thin screwdriver on the switch in there then turn on the ignition switch if it starts then it's your neutral safety switch that has to be replaced by the dealer or a good shop that you trust. It should still fall under the vehicles warrenty though.

ricoh-usa.com

That is from a dirty thermistor in the fusing unit. It is the one touching the pressure roller.

The waste toner is contained inside the belt unit that is mounted on the inside of the right hand door. Remove the screws that hold it together and dump it. Very messy so be careful. The message will go away by itself.

That code is usually a problem inside the laser unit - the polygon mirror motor.

defective toner... take it back to your vendor

SP Mode 5832-001

please clean the sensors located in the RADF and power the machine and the problem is over

That is a dirty thermistor in the fusing unit.

What model?

If the toner hopper assembly is not broken the mylars inside of it have fallen off over time. The toner supply unit needs to be replaced.

You have to set up the settings in user tools on the operation panel.