Lanier Office Equipment & Supplies - Page 4 - Recent Questions, Troubleshooting & Support

Paper problem or lift problem in tray 2, remove and reload paper, cycle power. -Carl

there are prints waiting to be printed delete them... -Carl

To clear enter service mode and cycle power,(push in sequence clear modes(yellow) 1 0 7 then hold the stop(red) for 5 seconds) -Carl

IH inverter current error at power on. Either the fuser is damaged or the invertor coil is defective. You really should have a Ricoh tech look at that one. It is not an easy fix for the layman.

Problem with the TD Sensor on the black PCU. Replace the PCU.

It is in the Ricoh maintenance kit.

Dirty thermistor in the fusing unit.

What model? That is a fuser error code.

Must have the paper loaded in landscape in one tray and portrait in the another. Then select sort mode on the panel when copying.

That is a dirty thermistor in the fusing unit.

Lubricated the bushings on the black foam roller on the inside of the right hand door. Toner leakage is unrelated unless the drum unit gears are causing the noise, in which case, it must be replaced.

Behind the front door, lower left. Just dump it and put it back

select manually on the panel.

If the toner hopper assembly is not broken the mylars inside of it have fallen off over time. The toner supply unit needs to be replaced.

You have to set up the settings in user tools on the operation panel.

SP Mode 5832-001

That code is usually a problem inside the laser unit - the polygon mirror motor.

What model?