Land Rover Recent Questions, Troubleshooting Help & Support

The system can be switched between On-road and Off-road navigation by pressing the facia NAV button twice, from anywhere in the system, then selecting On road or Off road, as required. https://www.ownerinfo.landrover.com/document/LK/2016/T19965/18686_en_GBR/proc/G1802885

https://www.roverparts.com/TechTips/Windshield_wipers.cfm It is possible that the wiper simply needs to be loosened. The above link addresses that simply fix, if it is indeed the problem.

As it is likely an OEM keyfob, it would be helpful to know the source/brand. It may indeed require a visit to a dealer. That said, here are a couple of links that may be of assistance: https://www.keylessentryremotefob.com/Key-Fob-Programming-Instructions-s/1856.htm https://itstillruns.com/program-key-fob-range-rover-7307259.html

Your 4.0 V8 has a whopping 188 hp. Try not to set any land suited records just yet. :)

Well, sounds like your ECM we had the same
Problem with our f250 no spark started and died lots of faultly codes if the ECM is bad it will
Show muilt. Codes and nothing really is bad..
Auto zone or Oriellys have the exact ECM you need for your vehicle they charge core charge.
We sorted a bout 150. With rebuilt ECM
After that the truck worked perfect for another
7 years till we blew the head gasket.. Lol
Working on fixing it now.. Hey good luck hope this helps.. And if you need the schematics of
Your truck try google they got all that for free online.

Hi, I also have this issue just started, did you ever find an answer?

this is fixya notify aa for transportation cost

https://www.youtube.com/watch?v=jFFp4ExM1Gc video indicates most likely oil cooler or head gasket https://landroverforums.com/forum/discovery-i-39/replacing-oil-cooler-hoses-84673/

http://www.fixya.com/cars/t12853582-change_fuel_filter_land_rover_freelander

Have you checked to make sure the security system hasn't tripped? These cars are very touchy when it comes to that. Also make sure your signal wire to the starter was hooked back up.

it failed to go into 4wd --actuator stuck --transfer case --module -switch -fuse -relay-

If you can verify that it is engaged, then likely a bad switch.

Your DII is (always) in 4 wheel drive. There is NO 2x wheel drive option on a DII, it's always in 4x4 high, or low. To select 4-wheel drive low, put your transmission in neutral and pull down the high low gear selector.

You can take it to a garage that can run diagnostics on your vehicle, as you need to plug in a laptop that has the diagnostic program on it and switch off the indicator. This also goes for engin mangement lights, airbag warning lights etc. As long as the garage has the correct diagnostic program they caan reset all the dash lights you want resetting. Hope this helps ;)

There are possibilities that come to mind.

The first (and I'm not familiar with your specific ride-on) is, often there is a speed limiter that only a parent can remove. It generally limits the speed to 1/2 full speed. Most often this is a screw located on the accelerator pedal that limits the pedal travel to 1/2 full range. Removing this screw will allow the toy to travel about 5 mph.

The second is the battery. Just because it develops 12 volts is no real indication that it can supply sufficient current to the motor. (Think CCA's as related to a car battery). Over-charging by leaving it connected more than 24 hours, or running it completely will damage these batteries and they wi never be able to produce sufficient output.

If there is no limiter artificially holding the speed down, I would try a new battery. Amazon has the best prices.