LaCie LaCinema - Recent Questions, Troubleshooting & Support
Nothing showing up on tv screen, only fuzzy lines
hi,exactly the same problem here. I could suppose its a firmware problem because it happen with or without the hard disk. I also checked "stand alone" the hard disk and it works properly.I'm trying to find if its possible to start an automatic firmware reloading from an external USB pen connected to box.
1/15/2013 10:58:40 PM •
LaCie 1TB...
•
Answered
on Jan 15, 2013
I do not know why
Welcome to Fixya
You should not be getting problems using RCA connection or HDMI connection. The blinking problem occurs if you have loose RCA connection at the back of the lacie going to the TV. Replace the RCA cable if connections are intact and still you are experiencing the problem.
Thank you for using Fixya! If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
I need to know how to do a factory reset on a lacie 4Big Quadra enterprise.
- Disconnect all cables from the device.
- Press and hold the "reset" button (located on the rear panel) for about 10 seconds.
- Wait for the device to restart and initialize. This may take several minutes.
- Reconnect the cables to the device and try accessing it again.
Note: It's recommended to backup all data stored on the device before performing a factory reset, as all data will be lost during the reset process.
My LaCie external drive isn't getting power
U should test for power at the connector that goes into the lacie with a voltmeter to make sure power supply and its wire are OK. If no voltmeter then use a automobile brake or turn signal bulb to see if it has power.
Not finding what you are looking for?