Kyocera Office Equipment & Supplies - Page 9 - Recent Questions, Troubleshooting & Support

Code J00 is paper tractions error, either one of the traction wheel or one of the sensor is stuck or defective, often you need to take apart the printer to fix this.

C6400 is a fixing unit error.

To reset -

Try this, enter "10871087" from keypad, You should now be in maintenance mode.
Enter "163"press "Start / Print" key.

You should see a screen that says "Execute".

Cursor / highlight "Execute".

Press "Start / Print key.

The machine will turn off and should come back to ready. If not then you need to replace the fixing unit.

I hope this is helpful,
Shawn

exposure lamp no coming on

disconnect network cable turn machine on if it comes ready then delete all pending or past print jobs from print queue

Hello, connect your copier in a network and you can use the drivers from this page https://www.kyoceradocumentsolutions.eu/index/service/dlc.false.driver.KMC2525E._.EN.html

just turn off authentication mode using admin login

Execute....turn off then on

Unplug for 5 mins.

press 1087 1087 than insert 163 than press start 4 time

Hi I have problem with my kyocera 4505

Unplug for 30 seconds

controleer wormwiel toner toevoer zit waarschijnlijk vast

Is one side lighter then the other side of the copy? Meaning uneven copy darkness? If so, I believe the problem is that one or both sides of the drum cartridge and the developer are not connected correctly. The two parts need to be close togather to make a nice dark copy. This model has a very wierd drum unit and has a defect that one or both side of the drum unit locking tabs break and you get very light or blank copies. It's some what coastly to replace the whole unit... That would be a worse case.... If it is just on one side you might be able to push on the cover on the side that is light. If the copies come out better. One side is broken..I would fold up some paper and make a wedge to push the catridges closer. Good Luck

If this is a color printer, it uses CYMK (Cyan, Magenta, Yellow, blacK) ink cartridges. MK would refer to the magenta and black cartridges. Older (one line) displays had limited real estate.

This code means machine's scanner home possition error. Try to check scanner home possition sensor if fixed in its possition. if not try to check scanner lamp unit movement .

There is a knob on the front of the cassette. Make sure it is set to the size of the paper.

press manu button then go to service then press right errow key goto status page press double enter it will print around 5 or 6 page in second page in down you can find the serial number or else see the back side of the printer it should stikared.............

the top of the waste toner container must be cleaned 100% from the toner because it should be a light sensor that has to pass through it , if its spoiled with toner the light cannot pass through it ,so i recommend you to empty the waste toner container first and wash it with water and drying it well before using it again.

These are scammers, dont respond...

Probably a broken corona wire. Replace the drum unit.