Krups Recent Questions, Troubleshooting Help & Support

More than likely only a new display will fix it, it is that whole front silver panel with the buttons and display plus a big part of the wiring loom going lots of places inside the machine.

Did you try the Krups web site for the manual? First place I'd go.

Hi,

See if you can turn the blades or reach a knife balde in to turn the blades....if something has jammed them.... get it removed... if they spin feely, then the motor is bad and replacement will probably cost more then a new one...

heatman101

I think you will find it here: http://safe-manuals.com/brand/krups

http://www.fixya.com/support/t9196987-need_manual

Look for a red re-set button. If it has one push it in. If no re set button it likely is dead. Make sure power outlet is working first.

https://www.boulangerhttps://www.boulanger.com/ecommerce/notices/4/3700342411294_n_0.pdf.com/ecommerce/notices/4/3700342411294

It’s telling me the brewing unit is missing ?

It is your device you can do anything you want to. The question is should I and the answer is no.

The manual is available here. Amazon.com, of all places. Whod'a thunk it?

You can try to put in a small bleeding resistor to push away the 30 Volts. However, this is not a proper solution. Check where the 30 volts have it's origin. If you spot a false connection somewhere, fix this.

Please contact krups for this error code. They refuse to give answers about how and what without the right code and machine number.

Sounds exactly like a heavy case of calcium buildup. Most likely you need to flush the machine with vinegar for a lot of times (10x) and use proper cleaning methods to clean it up by hand. However, i think it's faster to bring it to a repair service and pay 100 dollars.

Call krups and let the unit be repaired under warranty. Whatever they will tell, this is a design flaw and needs to be repaired by krups without cost.

Sounds like a defect in the main board. Call Krups customer support for what the options are in replacing the machine. This is not caused by yourself.

This indicates that one of the hoses has a small leak in the pipe right before the brewing compartment. Make sure the machine is descaled of course. If nothing improves, contact Krups support.

Probably the button underneath is stuck. This is a membrane button that can get damaged and doesn't make good contact anymore. Since this is an old question, i dont think it matters anymore.