Krups Kitchen Appliances - Others - Answered Questions & Fixed Issues

That is a neat toaster. It uses radiant ceramic bars. https://www.google.com/search?q=Krups+toastronic+deluxe+118 Lever not staying down https://www.google.com/search?q=Krups+toastronic+deluxe+118+lever+won%27t+stay+down ..

https://www.youtube.com/watch?v=u4vWfZLj5KY https://www.youtube.com/watch?v=yMy5W6Ul5j4

It's the wires going to temp sensor in lid. Take the drip catcher off and remove the screw on the plastic plate by the hinge, remove the black plastic cover and you will probably find that the screw had been driven through the wires at the factory.

This is a known issue with Krups kettles. If you are a handy person then you can remove the base and use a high temp gasket maker (auto shops have it) to add to existing silicone seal which goes bad after a couple of years.

Thoroughly clean it then try a little bit of oil.

Try http://www.manualslib.com They say they have 343 + Krups manuals available free for downloading.

Here is the manual in case you do not have it:. Scroll down until you find "Documentation" and then download the instructions. http://www.krupsusa.com/KITCHEN-APPLIANCES/DEEP-FRYERS/4-5L-Deep-Fryer-with-3-Baskets-KJ502D51/p/8000035750 As far as the error code goes, Krups does not list anything. However, there is a reset button on this unit (see the manual), it may need deep cleaning, OR the internal battery needs to be replaced. If none of that works contact Krups (number inside the manual or on the website) customer support and see what they say.

I do not know the exact inner workings of this toaster, but I can suggest what the fault may be. Many of the toasters use a separate high power section in the eating element for toasting. This part of the element could have gone defective. There is the possibility the computer board that directs the power for the higher temperature mode for toasting has failed. The only reliable way to know is to try the computer board, element assembly, or the switches if the switches are on a separate module than the computer board.Just to add... These toaster units usually have a thermo protection fuse. These fuses have a temperature rating. It would be in series with the element. This fuse may have failed. This is a common fault in many of these types of units. This type of fuse is rated in Degrees C or F, and not in Amps. it is a thermo fuse.

" just recently bought my krups kettle and last week "

TAKE IT BACK AS DEFECTIVE FOR EXCHANGE OR REFUND

Sounds like your toasters heat selection switch is defective or the knob my be stripped that adjust the heat level..try pulling the knob off and see it is..To check use a small pliers to turn the switch manually to the lighter or darker mode if it gets hotter and cooler it is the knob if not the switch must be replaced..good luck

Both the chicken and the egg came at the same time. I’m happy to help further over the phone at https://www.6ya.com/expert/joshua_ac64e182ed26f66d

It is probably just a calcium deposit stuck in the sensor intake. Try running a diluted vinegar solution through the full coffee making cycle. No coffee of course, and run clear water through a few times afterwards to get rid of the vinegar taste. You might need to do the vinegar a second time if the first doesn't fix it.

To make rice, remove the trivet if you have one as this is only for steaming food. Wash rice to get rid of excess starch and put in pan. Then add the same amount of water as rice (2 cups water to 2 cups rice etc.) then shut lid and switch on and leave it. Once it has switched off do not open the lid for a further 20 minutes (the machine will keep the rice warm do not worry) Stir rice and serve. Most rice cookers will keep the rice warm for a couple of hours. If you find the rice is a bit dry then add a little bit more water, the amount of water really depends on the quality of rice used.

cant be much different that making a conventional omelet..

my deep fryer doesn't produce heat anymore what can i do? Were do i go to get it fixed in montreal or surrounding area???

Sounds like a faulty internal thermostat or it needs to be adjusted.

The model number is actually FDH212. Here's the manual from Krups USA: http://www.krupsusa.com/NR/rdonlyres/B538D70F-8F15-4BB9-92CE-9E493621DC11/7356/Ricecooker_usa.pdf

The printed circuit board is likely burned out. It's pretty sad really. This is a poorly designed toaster. Krups owes us new toasters in my opinion. Looks like a fire hazard too. If you are curious, you can remove the 4 philips head screws out of the bottom of the toaster, gently pry off the push down lever and the dial, and examine the board and connections.

I believe this is the manual you're looking for.

I found a solution to the spewing around the lid and through the vent.The other day I placed the steamer tray in the top and then the lid. The steamer "broke up" the bubbles -- no spewing out of the pot or mess -- I mostly happened with brown rice -- but the last 2 times -- not mess!!!!! Hope this helps someone else.