Konica Minolta Office Equipment & Supplies - Page 5 - Recent Questions, Troubleshooting & Support

Replace the black image unit not toner

replace the magenta image unit

Replaced. Or it could be the main board.

What is the model number?

Would help to know the model of the machine

Replace the transfer belt.

NO such code for that machine Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

exposure lamp or CCD issue. both located under the big glass. The CCD is the large black device on the right. The scanner is device on left that lights up scan a document though the Doc feeder or main glass. try this reset FIRST, if this code comes back. Have a technician look at it DO NOT CONTINUE TO RESET the code!!!! AS this is for the Hot Part called the destroy the lamp or CCD 1. Turn OFF the main power switch. 2. Turn main power switch ON while pressing the Utility/Counter key. 3. Touch [Trouble Reset]. 4. Check to make sure that [OK] is displayed and the it has been reset. 5. After turning off the main power switch, turn it on again more than 10 seconds after and check if the machine starts correctly Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

When you open the right side door and look down at it you see a sponge looking roller. That is called Second transfer roller. The paper will go between that roller and transfer belt the shinney belt inside the machine it aligns with. During operation the roller should retract. There is a senor and motor that work together to execute the procedure. You will have to remove the assy. to get to the motor and sensor if its not them its the main board serious buckets and I doubt you can get one.

I need to be able.to.fax on my machine

(40020001)Internal 1.

that code is not listed anywhere. https://www.google.com/search?q=C1070+printer+error+code+c-4526 ..

Image unit motor failure. Replace the image unit. Or the gear pack for the motor or the Motor worse case its the main control board.

Go on line purchase a new waste toner box and replace it you can also dry to vacuum the box out. but watch what you use as a vacuum clear as older ones don't have the best filter and toner can run strait though it making a mess

Remove the paper behind the paper draws

Sir/Mam,Recommended you have a technician come out to re flash the copier operating system (NOT printer driver). But the software that runs the copier, it is located at a secure web site at Konica Minolta, any firmware is access able to dealerships and KMBS only. They like to protect their copier Operating Systems.

Replace the image unit which includes the drum and developer and ensure clear drum and developer counters and you run the F8 procedure.

What is the model of the machine?

Replace the Black drum and developer unit (P9) (P16) and clean the IDC forward sensor(P5) (Requires removing the Transfer belt) L4 Black Drum Rotation well passed its life.

https://www.google.com/search?q=Konica+Minolta.+Why+doesn%27t+the+blade+clean+the+magenta+after+printing+color ..