Konica Minolta Recent Questions, Troubleshooting Help & Support

I found a Minolta site in Germany where you can download drivers for win 98. For the newer Windows (2000, XP, Vista, 7 and 8) the drivers are already in Windows. Second link is for the transfer software.
Link to drivers for Minolta in Win 98
link to Konica Minolta transfer software

Most likely you received this message after a toner was replaced. Reseat the cartridge and restart the printer. If that doesn't work remove all of the toner cartridges manually and reinstall. Turn off the printer and open the top cover. Follow the toner cartridge all the way to the right side of the printer (on the white part). You should see a hole that looks like a cross. Take a pen or key and push down on the black button in that hole. While you are holding it down rotate the toner cartridge towards you. You want to get the colored roller on the cartridge about 1/2in away from the metal bar that says "consumable reorder". You should be in a position to take out the toner. Let go of the hole and remove the cartridge. Repeat the steps until all of the cartridges have been removed. Turn the printer back on at this point. You are going to get toner not installed messages on the printer. Open the top cover and the cyan tray will be in place. Shake the toner and install. Close the cover and let it cycle to the next color (black). Repeat the process until all cartridges are installed. If you are still getting the error you either have a bad cartridge or the carousel that the toners sit in is damaged.

Your option CU-101 that is attached to your machine has a fan that is not turning. Open and close front door. to reset

what lamp error

HDD Hard Drive failure

You cleared the code in service mode?

where and what jam code

Did you open both middle sections ? check that the bottom middle section bottom is properly closed

NO Load check in the model. just a sensor test

is there a code?

Align the ADF to the machine itself

Turn off the machine, remove the toner bottle, then power on with the bottle out let the machine do its start up procedure. one it asks for the toner bottle install it correctly

Is there a code???

You have a problem with the HDD (Hard Drive) Main Memory Stick or the extra one if installed or worse case the Multi Function board. Have tech come out

Tri-folder motor malfunction. or bad motor

its done automatically and you can do it in the service mode

Need the model number of the machine

Check the print driver on those computers are you using the proper drivers?

What is the code!!!!!!

Multi function board bad (MFPB)