Kodak Cameras - Answered Questions & Fixed Issues

The microphone is the tiny hold under the left side of the lens. Make sure your finger isn't over it. There are 4 levels for volume including MUTE volume High Medium Low Mute https://www.manualslib.com/manual/89073/Kodak-Easyshare-M5350.html?page=47&term=volume&selected=2#manual and https://www.manualslib.com/manual/89073/Kodak-Easyshare-M5350.html?page=31&term=volume&selected=1#manual When in doubt, Read the Manual! ..

1. Take it back and tell them you want a new one and you want to see it working in the shop. 2. Buy a Used Nikon D90 :>D

Question translated into written English, add CAPS, fix typos and remove text speak abbreviations. Question moved to Model Category. Try this reset fix.

I have a Kodak Easy Share C513. The flash doesn't work

JustAnswer https://www.justanswer.com > Camera Problems Dec 28, 2012 - 1. Remove the battery and memory card from the camera. ... for approximately 20 minutes. 3. Reinstall the battery and power on the camera and let ... 1 answer · Top answer: It is not minor problem.If it is not under warranty then please don't send it to service ... Missing: m853 ‎' Show results with: m853

I have a kodak easyshare m753 the flash wont work

Fixya https://www.fixya.com > support > t3124129-kodak_e... Jul 15, 2009 - Remove your battery and memory card for 15 min and put them again. (you can also try by putting new batteries. In some cases battery can be ... Or camera repair near you. https://www.google.com/search?q=kodak+digital+camera+repair+near+me .

It needs to go back to Kodak for firmware and software repair. https://www.google.com/search?q=Kodak+EasyShare+C160+stuck+in+date+and+time+reset+mode ..

To set the date and time on your camera, follow these steps: Turn on the camera and set the language and date/time by following the instructions in the Extended User Manual. Once you have set the date and time, you can turn on the Date Stamp feature by following the instructions in the User Manual . The date and time will be stamped on all pictures taken with this feature enabled. KODAK CD82 - EXTENDED GUIDE EXTENDED USER MANUAL Pdf Download ' ManualsLib KODAK EASYSHARE CD82 USER MANUAL Pdf Download ' ManualsLib

they are easy to change contact kodak and see if you can order a replacement cover.

Seems battery issue. Try replacing battery.

If your Kodak 600H projector is beeping when you turn on the lamp but stops when you turn off the lamp and leave the fan and power on, it could indicate an issue with the lamp or its connection. Here are a few possible explanations: 1. Lamp Replacement Needed: The beeping sound could be an indication that the lamp needs to be replaced. Projector lamps have a limited lifespan, and when they reach the end of their life, they may produce warning signals, such as beeping, to alert the user. 2. Lamp Connection Issue: Check the lamp's connection to ensure it is properly seated and securely connected. If the lamp is not properly connected, it may trigger an error and cause the beeping sound. Try removing the lamp and reattaching it, making sure it is correctly aligned and connected. 3. Lamp Compatibility: Ensure that you are using a compatible lamp for your Kodak 600H projector. Using an incompatible or non-genuine lamp may cause compatibility issues, triggering the beeping sound. If none of the above steps resolve the issue, it is recommended to consult the user manual for troubleshooting instructions specific to your projector model. Additionally, contacting Kodak customer support or reaching out to a qualified technician for further assistance may be beneficial.

No, SD Cards only. Page 53 of the manual. https://kodakmanual.com/kodak-easyshare-dx7630-manual/ and

I have a Kodak EasyShare DX7630. I bought two new SD ...

JustAnswer https://www.justanswer.com > Electronics Question Mar 5, 2020 - Your old camera model DX7630 only supports SD memory card type, which has size of 2GB or less. Your camera does not support SDHC card type ( ... 1 answer · Top answer: Hi, I'm sorry about your camera issue. I'm glad to assist you today. Did you purchase new ...

Kodak EasyShare DX7630

ZDNet https://www.zdnet.com > product > kodak-easyshare-d... The camera includes an SD memory card slot located next to the battery compartment. The purchase of a 128MB or greater SD memory card when you buy the camera is ... Pros and cons: Picture quality is excellent ? Battery life is excellent ? Easy to use menus ? View full list ..

Question edited for clarity and written English. Question moved to model category. You are the only person to report this problem. It has failed electronically. The only thing you can check is that the battery contacts are clean and shiny. If they have had a depleted battery in there for a long time, they may have corrosion. If that checks out okay, you need to take the camera to a Kodak service centre or a good camera shop for repair. https://www.google.com/search?q=Kodak+EasyShare+CD14+Digital+Camera+is+not+switching+on ..

No, don't try to fix cameras. Send it in for repair and service.

Try a Reset as mentioned here. https://www.fixya.com/support/t1099044-kodak_easyshare_z1275 https://www.google.com/search?q=Kodak+Easyshare+Z1275+freezes ..

There are a few possible reasons why your Kodak Easyshare Z740 camera might be turning off while you are trying to take pictures:

1. The battery might be low or dead. Try replacing the battery with a fully charged one to see if this fixes the issue.
2. There might be a problem with the camera's power supply. Try cleaning the battery contacts and charging the battery to see if this fixes the issue.
3. There might be a problem with the camera's firmware. Try updating the firmware to see if this fixes the issue.
4. There might be a problem with the camera's hardware. If the camera is still under warranty, you should contact Kodak for service. If the camera is not under warranty, you may need to take it to a repair shop to have it fixed.

I hope this helps! Let me know if you have any other questions.

Hi, please ensure that the battery isn't past it's expiration date- even if it's not been used before, an expiration m. And please ensure that the sd card does not have more data stored than was built for the camera to handle. If so, please transfer some data off of the sd card and then attempt to set the date on your camera again. Thank you.

Hi, Please make sure that your camera doesn't have a black cover or tax over the lends. This would block any images from being stored whenever you attempt to take a picture. In other words, the camera wouldn't be able "to see". If you can't find any cover, please check that you've properly inserted an SD card for the camera to use and then switch modes (ie action, night time etc) until you see the area that you're attempting to capture come on the camera screen. Otherwise, you might need to get the camera checked at a store like BH Photo and video. Thank you.

Hi, You can locate the manual for your kodak camera on the Kodak Manual website or the Manualslib website. All you would need to do is enter the product name in the search and press enter to be shown the results of search which should list a link to the manual that you need. Thank you.

Hello

The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the probability is that you will have to get it fixed by a professional.

Use these at own risk as it may further damage the camera.

Firstly , try connecting your ac adapter or usb cable.

Try holding the shutter button while switching on the camera.

Look at the lens , and if some of the lens 'circles' is misaligned or not concentric then try wiggling it (while holding camera lens down).

Try gently pushing or pulling the lens when it extends but this is risky as it may cause the lens barrel to slip out of its guidance system.

Another way to do this is to place the camera lens down on a hard surface and then power it up. Be sure to use a soft cloth or something similar as to not scratch your lens or casing. Let the lens push the camera up and down a few times and sometimes the little resistance provided by the camera is enough to get things going again.

Try hitting your camera near the lens on the body with the soft tissue on the palm of your hand.

Other than that , I would take the camera to a repair center for a evaluation to see if it would cost more to repair than to replace the camera.

If it is still under warranty I would suggest you take it in before trying any of these steps and remove any off-brand batteries or accessories as some stores are really fussy about warranty repairs on camera's with non-brand accessories.

You can also have a look at THIS link.

Hope the advise is useful. please do not hesitate to let me know if you need any further assistance. Also, please be so kind to let me know if you found this helpful.

Regards
Andrea

Question edited for clarity. I doubt there is a way apart from removing the battery for 5 minutes. It is a point and shoot. https://www.google.com/search?q=kodak+cx7525+reset+to+factory+settings ..