Digital input
It depends. It either a Digital Coax cable(looks like an RCA cable), or it an Optical cable. The two look nothing alike.
Program the klh r7000 remote
With the unit disconnected, remove the top cover to reveal the fuse, which is located near the large capacitors, diodes, and power transformer
netgear r7000 speeds supports both 2.4GHz and 5.0GHz wireless frequencies, . I believe the issue with your receiver is more serious than a blown fuse. Check for a short circuit before replacing the fuse. If there is a short circuit, especially in the power amp section (which is frequent to fail), replacing the fuse without testing it may make the situation worse.
12/15/2013 3:33:59 PM •
KLH R7000...
•
100 views • 0 helpful votes
Tried 0214 code for Dish Network remote. didn't
Hi there! My name is Kimberly and I form part of the Social Media Department with DISH. It is my pleasure to assist you today and provide you with information that may be helpful to you. Where you trying to address the remote to the TV or a different device?
With the *desired equipment* on, press and hold the *desired mode*
mode button (about six seconds) on the top of the remote until all mode buttons
light up, then release. Press 0-TV/1-VCR/DVD/2-Other, then press STAR
Press
the Up arrow button once per second while pointing the remote at the
*equipment*. If the code for it comes up, the equipment power off.
When
it does, press the POUND button. If the code entered is valid for the remote,
the mode light will flash three times. To verify the code works try several
different functions for that equipment.If you have additional questions visit
http://www.mydish.com/support/program-to-tv-scan-non-basic?WT.svl=leftnav or contact me directly at:
[email protected] Media RepresentativeDISH L.L.C
On one side of the receiver a dyoid blew, is it
No more likely the fuse would blow because of the diode! Fuses blow when there's an overload. These are general caused by semi-conductor device such as a transistor or diode that starts acting like it's just a piece of wire. Or as engineers call them short-circuits.
8/18/2013 12:19:23 PM •
KLH R6500...
•
54 views • 0 helpful votes
Tuner presets
manual tune to desired station, press and hold the number button you want that station asigned to, rinse,repeat
3/23/2013 7:05:17 PM •
KLH R5100...
•
122 views • 1 helpful votes
Klh model 20 no volume
what kind of speakers do you have hooked up? make sure your cables from the speakers are good. you should have an RCA type hookup on your record player, make sure they are in there good too
Deck a will not eject
It is a belt that is loose and the motor that is slipping is the noise you hear. Usually if you can get the belt out and measure it subtract 5%
KLH ASW8 Powered subwoofer keeps blowing 3A-250V fuses
The transistors at the output stage of the sub amplifier circuit might be shorted so each time you power on, the circuit draws a very high amount of current which causes the fuse to blow. It's definitely a problem with the circuit so using a higher current rated fuse would probably just result in damaging the amp even more. You should ask a qualified electronics technician to take a look at it. I hope you can fix it.
My I got sound but no picture on my DVD player
There are three coloured leads on the back of a DVD player if you use composite video - Red is Right channel sound, white is Left channel, yellow is video.Red from DVD right output to TV right inputWhite from DVD left output to TV left inputYellow from DVD video out to TV video in
How to play DVD
plug it in hook the wires up hit the arrow button that will open it upput the disk in and it should work
Not finding what you are looking for?