KLH Audio Players & Recorders - Page 6 - Recent Questions, Troubleshooting & Support
How do I turn off parental control on a DVD player?
Go back into the set up and factory set it then go back through the end user set up again. Sony bipass code is 7774 for parental control Not sure where that 1s made. That dont work track down the customer service number for the manufacture
18 volt supply too low. resistor R42 burned. Q20
I would fit the same type, unless the schematic shows a change, which clearly it doesn't. However I would be surprised if R42 burnt up alone! Look at the schematic, is R42 linked to any other transistor or part? If so check them if you can.
By the way is R42 a fuseable resistor, for example is the symbol on the schematic or on PC board different to most other resistors?
How to install KLH asw10-20 to a 7.2 receiver
Yes, the 10-120 can use a L & R low level subwoofer input. You can get a short 6" RCA splitter adapter from Radio Shack for a under $10. (1 female input, 2 male outputs) Alternately, just plug the subwoofer output on your receiver to just the low level R channel on the KLH sub.
1/21/2015 4:37:42 AM •
KLH Audio...
•
Answered
on Jan 21, 2015
Sub woofer produces a very loud low tone
This model has a high failure rate with the power supply board.
Typically, power resistors fail, which in turn burns out the big
capacitors.
I have not heard of transformers failing though, so it shouldn't be too much to repair it.
Here are the schematics for the unit:
Upper board and
Lower board
Klh subwoofer keeps blowing it's fuse.
Most likely the amp in the sub has blown. It will need repair or replacement. I'd take it to an expert in repairing amps, it's not a job for you unless you're experienced in troubleshooting these things.
1/1/2015 10:05:37 PM •
KLH Audio...
•
Answered
on Jan 01, 2015
Not finding what you are looking for?