KitchenAid Refrigerators - Page 6 - Recent Questions, Troubleshooting & Support

Thermostat again.

yes there should be a valve on the water supply to refrigerator, if have one installed

if you can hear the motor running all the time, its either compressor fault or a gas leak eith is expensive to repair, if moor not humming the nthermostat or compressor

Pull the drawer all the way out. About 3/4 of the way back of the rails on each side is a plastic locking tab. Push the tabs in and pull the drawer the rest of the way out.

• suggestions If the compressor runs and there is no cooling then there is something wrong with the circulation of the refrigerant gas , if no compressor runs the startrelais of the compressor ,or the electronic assembly defect , or only simply in most cases the thermostat defect a solenoid valve somewhere (and if there is )> a cooling fan not turning.

KitchenAid 2001 Model Built In Side By Side Refrigerator with Variable...

Look at the top of the fridge inside to see the switch

http://www.calechelashes.com/3d-silk-eyelashes/3D Silk Eyelashes 3D Silk Eyelashes China Factory 3D Silk Lashes With Own Brand Package Wholesale hot fashionable premium individuals 3D Silk Eyelashes with private packaging.We are big lashes manufacturer and can provide factory price.Our 3D Silk Eyelashes is natural comfortable and beautiful.And our lashes can wear many times and can fast delivery.If you have any question you can contact us. 3D Silk Eyelashes China Factory Hot Sell 3D Silk Lashes

Remove service panel & check operation of compressor. If compressor is running, check condenser fan motor(should be running with compressor). If components are running, a certified refrigerator tech must check refrigerant.

has someone turned it off at the controls? Is the screen abnormally blue or blank? I'm thinking a lose connection or a defective control board.If you would communicate with me I can help you find the problem Control board can be found=> HERE APPLIANCE911 E-Mail Contact Me Here KitchenAid Refrigerator Model KFIS20XVMS2 Parts

The ice unit is available online. U can disassemble the unit and see if u can spot the problem also. It is not complicated If you need further help, reach me via phone at https://www.6ya.com/expert/gary_9c859f4aa7e5ab10

You have something wrong with the vent going from the freezer to the fridge. You probably have a defrost problem and ice is blocking the vent that goes from the freezer and comes out in the roof of the rerigerator compartment. Replace your defrost timer and bimetal.

Is there a wire/bar that goes across the ice bucket? As ice fills the bar raises up and eventually goes high enough to shut the maker off until the level goes down. You can manually lift the bar up to ~ horizontal until it clicks in place and stays there. That should shut it off until you move it back down. If there is no bar, then I guess there in no way your ice maker knows when it is full and keeps producing. Perhaps the bar was removed, bent or broken off. At least tht is one type of ice maker I'm familiar with. Other types my have different ways to tell the maker it's full.

if everything is fine, then what is the question ? if it isn't cooling, get a trained refrigeration technician to look into fixing it. refrigeration equipment takes specialized equipment and training well beyond the average homeowner tools or skillset.

if water keeps running to the icemaker, a valve has been obstructed by scale/lime/granular particles, and cannot close when icemaker has filled with water. you need to find that valve and either clean it out or replace it. (or get a repairman and pay the price for the fix.)

you might want to call 877# and see what these folks have to say. http://www.appliancepartspros.com/repair-help/kitchenaid-refrigerator-kssc42qms03-repair/kssc42qms03-wont-start.html Very helpful folks you can even do a chat if you want to instead. hope this helps you

How about a short metal screw? Drill a small hole and install. If it works, back it out a turn, put a drop of Super Glue on it and screw back on.

I hope I'm leading you in the right direction... try this site...I found the part I believe and there is a install video there... http://www.appliancepartspros.com/whirlpool-valve-solenoid-single-wp2313917-ap6007232.html hope it helps.

If you get us a Model # it would help FIXYA Folks help with some suggestions. Should be Inside the refrigerator, on the left wall. silver sticker. Thanks

How often do you change filter. Maybe filter was so clogged that it wasn't allowing water through