KitchenAid Kitchen Ranges - Popular Questions, Answers, Tips & Manuals

Question edited for clarity and add Maker. Question moved to maker category. Number 1 Tip, never ever use the self cleaning feature. It only exists to break the appliance and create the need for parts and service calls. The temperature is just too intense for the parts. A self-cleaning or pyrolytic oven is an oven which uses high temperature (approximately 932 °F (500 °C)) to burn off leftovers from baking, without the use of any chemical agents. The oven can be powered by domestic (non-commercial) electricity or gas.

Why You should Never Run A Self Clean Oven Cycle & ...

General Appliance Service https://www.generalappliancesvc.com > why-you-shou... Jan 29, 2020 - A self-cleaning oven is a feature on many modern ovens that burns off cooking spills and splatters with an extremely high temperature (932 F° or ... -------------------------------------------------------------------------------------- The only thing suggested is doing a power cycle, but the heat has probably fried the control board which is located too close to the oven and all that heat. https://www.google.com/search?q=KitchenAid+KGSS907SSS00+F3+E3+Error ..

The issue with the oven display light and the oven light on the KitchenAid Stove KERS205TSS 2 may be related. The problem with the oven display light could be due to a faulty control board or a malfunctioning light switch. The control board may need to be replaced if it is not sending a continuous signal to keep the light on. On the other hand, if the light switch is defective, it may not be able to maintain a connection to keep the light on. The issue with the oven light staying on could also be due to a faulty light switch. If the switch is stuck in the "on" position, it will not turn off even when the door is closed. This can cause the bulb to burn out prematurely and waste energy. To fix this issue, you may need to replace the light switch. It is possible that both issues are related and caused by a malfunctioning control board. If this is the case, replacing the control board should fix both problems. To fix these issues, it is recommended to contact a certified technician or an authorized service center for KitchenAid appliances. They will have the expertise and tools necessary to diagnose and repair the stove safely and effectively.

ck this out,,,,, https://www.appliancepartspros.com/repair-help/kitchenaid-range-kgrc707lbs0-repair/kgrc707lbs0-little-to-no-heat-when-baking.html also Repairclinic.com Best to you

We are FIXYA dot com, we aren't Kitchen Aid. You error needs a service call, because it probably needs a new control board. These aren't cheap so it needs professional diagnosis. https://www.google.com/search?q=AM71+UI71+EEKGO-010+error+04 ..

The switch that makes it spark?

Age-related control failure

That is probably the SAbb code; the Sabbath mode has been set. This mode allows you to heat a meal while fulfilling the "no work" requirement for strict observance of the Sabbath. The oven will stay at the programmed temperature until you change the temperature or end the Sabbath mode. To end the Sabbath mode, open the oven door and press and hold 6 for 5+ seconds. Then close the oven door. Searching Kitchenaid's support site, https://www.kitchenaid.com/service-and-support/manuals.html , I found the manual for the KESC307 ranges here: https://www.kitchenaid.com/content/kitchenaid/en_us/searchresult.html?term=KESC307&tab=clp&plp=&plpView=grid&clp=kesc307 . The direct link to the manual is https://www.kitchenaid.com/content/dam/global/documents/200308/owners-manual-9754287-RevC.pdf . See page 18-19 for the information on the Sabbath mode. You can completely disable the option on the range by following the steps in the manual. I hope this helps. Cindy Wells

The element is accessed inside the oven at the rear wall.

Have you unplugged the appliance I reset it see if that clears it

I didn't see an operator manual using https://www.google.com There were several diagrams and parts lists. An installation manual and a toll free number to call for support is at the link below: https://www.partselect.com/Models/KESH307HBS4/

Same here. I am in trouble like that. Need to find a solution! Best, http://giaydankinhgiahuy.com/

here is the manual. If it is an LED bulb it may be bad. LED's tend to blink constantly when bad. https://manualsbrain.com/en/manuals/908701/

Do you mean the KGSS907SS01? Kitchenaid ranges usually don't have three letters before the last two digits in the model number. If so, all you need to do is press the Clock Set/Start keypad (below the 7) and then type in the current time. Then press the Clock Set/Start keypad again. The range uses a 12-hour clock. I found the Owner's Manual at Sears Parts DIrect: https://www.searspartsdirect.com/partsdirect/user-manuals/kgss907sss01-kitchenaid-parts-manual . The instructions for setting the clock are on page 12. The direct link to the manual is currently https://c.searspartsdirect.com/mmh/pd_download/lis_pdf/OWNM/L0809512.pdf . Manuals Lib does list a KGSS907SSS model. The manual is available here: https://www.manualslib.com/products/Kitchenaid-Kgss907sss-30-Inch-Slide-In-Gas-Range-12919.html . The directions for setting the clock are the same. I hope this helps. Cindy Wells

The oven control board will need to be replaced to fix this problem. The part you need is # 6 in this picture.

Is it an electronic unit or piloted unit

Odds are that element is bad and needs replaced some minor testing needs to be done to know for sure. I have attached a picture of the elements as they are different depending on position. #12 is the part. Sears parts direct can get you the part numbers.

It is usually located on back wall of unit behind removeable metal panel. Unplug before servicing.

Have you tried running the exhaust fan when using the stove? Also you might try using the back burners. It sounds like the microwave is sitting too low and this may cause more issues as the time goes on.