KitchenAid Dishwashers - Page 9 - Recent Questions, Troubleshooting & Support

First try to unplug and then plug it back in. Hopefully this will reset the dishwasher. Good luck.

Dishwashers are made to last 5 to 7 years.

Try flipping the break in fuse box. It may reset control panel. good luck

See if there is a start button on the right side of that control panel.

Sounds like a bearing in the pump is going. This would cause a leak be careful leak will get worst.

Most likely, the eelectrical solenoid that releases the door's latch has failed. The control board may be the fault. The solenoid is in the door and in many models the board is too. If you wish to inspect either component, do it safely by insuring the power is disconnected. Some troubleshooting requires the power to be on. If you're comfortable working with live circuits, practice the utmost in safety. Let us know...

Sounds like a heating problem you might have to change the controls and heater

Make sure the door switch in the latch assembly is being activated.

There is a fan blade on the top of the pump shaft. IT is loose. They are pressed onto the shaft. The only thing you can do is replace the motor or the whole machine.

Put some kind of washer on the spindle to stop the up and down motion of spinner. Manual can be gotten at mfg web site or google search. For the residue I would use a sudsy ammonia cleaner or grease cutter. Or a baking soda paste .

Go to attached site for diagram and location of part Search Over 2 1 Million Appliance Parts