KitchenAid Dishwashers - Page 5 - Recent Questions, Troubleshooting & Support

Please provide s model # so I can give right answers because there is few deferent model was built

First, remove internal filter below the bottom rotor. Work carefully so you can reinstall. If you have a wet/dry vac, shopvac, remove the filter bag and then suck out the water and clean the bottom of the machine. ( the sump, the low spot inside the appliance. ) Sometimes a popcorn husk or a bit of glass or plastic can get by the filter and clog the pump. The sump is designed to retain a little water between cycles to keep the seals wet so don't worry if there is a bit left after a cycle. (not enough to cover the bottom but a 1/2 cup or so). If this doesn't solve you problem, check the drain hose from end to end. Sometimes it can get too sharp a bend or plug at the sink end.

Replace the control panel.

Turn the power off for a minute or unplug it for a minute.

In the bottom of the dishwasher, there is a filter the size of a glass, twist it and it will release.

Hold the 4 hour delay button down for 3 seconds.

You can try cutting power to unit a breaker box for a couple minutes. That may reset the electronics. If that doesn’t work, then control board is most likely defective.

Stainless Steel are alloys that are made up of iron and generally contain around 11.5% chromium. The addition of chromium allows the alloy to form a protective self-healing oxide film, thereby making them resistant to corrosion and oxidation even at extremely high temperatures. Due to this feature, stainless steel is used for making products across many fields. For obtaining special properties, nickel and other elements can be added to this alloy. Stainless Steel has excellent resistance to corrosion, protection against corrosion, hygienic material, good strength and ductility, ease of fabrication, ease of maintenance, excellent durability. Stainless steel is less reactive with foods as compared to other materials. Therefore, it is used in different industries such as Food industry, Pharmaceutical industry, Petrochemical industry, Automotive industry, Construction industry, Oil and Gas industry, Medical field, Water and sewage systems, Aviation engine components, Nuclear industry. For more information Click Here Stainless Steel Flanges Manufacturer Stockiest Supplier

Hi..Push the energy save button and hold for at least 4 seconds.This will solve your problem.

I see no question here.

First, I'm not a Kitchenaid representative. * Check your warranty. Call for support; 1 (800) 422-1230 * Contact; https://www.kitchenaid.com/major-appliances/refrigeration/refrigerators.html *** The following is for information only.*** * Official "How to maintain" (see cleaning); https://producthelp.kitchenaid.com/Refrigeration/Full-size_Refrigerators * Removing trays; https://www.youtube.com/watch?v=fvoO_x55u3E * Crisper Drawer info; https://www.youtube.com/watch?v=U3bfBAVqaJc Aloha, ukeboy57 Additional information; * Track replacement (Roper); https://www.youtube.com/watch?v=Boh8vhEIt2w * Vitafresh; https://www.youtube.com/watch?v=z5WfVC2OaVA * Support truck; https://www.youtube.com/watch?v=9SazO4SMTqY

I would suspect that the control panel is shorted.

First, I'mn ot a Kitchenaid Representative.* Check your warranty. Call for support.*** following for imfomation only.**** Reset; https://www.google.com/search?q=kitchenaid+dishwasher+reset&ie=utf-8&oe=utf-8&client=firefox-b-1-ab* Reboot; https://www.youtube.com/watch?v=XJnzzXJcOV4* Not running full cycle; https://www.youtube.com/watch?v=QTr0HSwuCCw* Control Locked; https://www.youtube.com/watch?v=BZUUR39bawY* Error codes; https://www.youtube.com/watch?v=Ti48mP2ShKk* Starts then stops; https://www.youtube.com/watch?v=Okfns8OoR1g8 Reset button?; https://www.youtube.com/watch?v=113SZ39zmtI* Cleaning filter Part1 (of 3); https://www.youtube.com/watch?v=Wttz4fB1yVs* Note; opening internal (of box) may void warranty. Call for service.Aloha, ukeboy57

The dishwasher may use the heating coil to increase the water temp, Also utensils fall into the bottom of the unit and can melt. The heater coil may be about to fail and when this happens the temp increases. The filament inside the coil may have worked its way to the outer shell. Last but not least, the pump motor could be overheating.

check here for a pic....... http://www.appliancepartspros.com/control-panel-latch-parts-for-kitchenaid-kudc10ixss4.html there is a screw part # 4 that maybe loose or missing. though it doesn't show one on each side ck it out. hope this helps a little.

Sears Parts Direct, https://www.searspartsdirect.com/model-number/kfcp22exmp1/0593/0161000.html , lists the refrigerator door panel for the KFCP22EXMP1 for $387.47 . The freezer door panel is $517.17 . This is the only site that I found that lists the doors as in stock. This status may change without notice. I hope this helps. Cindy Wells

Could be the motor itself or possibly the capacitor (if there is a seperate one)

Hello -The cause of the stains on the interior of your dishwasher may be the water. Do you know if you have hard water, water with a high mineral content? If so, do you know if the water has a high iron or maganese content?If you have hard water in your home water supply and do not have a water softener, check the owner's manual for your dishwasher - the Troubleshooting section - to see if there is mention of stains on the interior of the dishwasher.+++From the American Cleaning Institute web page on Automatic Dishwashers:http://www.cleaninginstitute.org/clean_living/automatic_dishwashing_problems.aspx#YellowYellow / Brown StainsCauses: Iron or manganese content in water supply.Solutions: After food soil is removed, wash dishes with citric acid crystals. Check dishwasher manufacturer's instructions for amount to use and method. Do not add detergent. A liquid product is available to remove iron deposits from the dishwasher interior; follow the package instructions. To retard staining, use maximum amount of dishwasher detergent to keep iron or manganese in suspension during the wash. Use a rinse additive during the rinse.Preventative Measures:If staining cannot be controlled, the only solution is in the installation of iron removal equipment in the home water supply.+++Some solutions to the interior staining problem recommend the addition of citric acid crytals to the covered section of the dishwasher detergent dispenser. If you do that, be sure you do not have any sterling silver or silver plate tableware in the dishwasher. (Those items are best washed by hand, anyway.) Citric acid will cause pits on sterling silver and silver plate. Note: Some dishwasher detergents and dish liquids have citric acid in their formulations - check the ingredients.Best wishes.

if the light is flashing 7 times there's a heat problem and the dishwasher won't start,if you remove the bottom kick panel you'll see the tech sheet,it will tell you about the flashing error codes, count how many times it flashes and look up the code,if it is 7 times you either have a bad heater or computer board,if you look at diagram it will show you how to read out the heater from board to see if the heater is bad or it's the board.