Kia Popular Questions, Answers, Tips & Manuals

"The cooling fan relay will be commanded ON when the following conditions are met: - The engine coolant temperature reaches 106°C (223°F) or more. - The A/C clutch requested. - The vehicle speed is less than 38 MPH." The heater is not one of the conditions that will turn the fans on.

Change the fuel filter as there shouldn't be a 'lot' of resistance. Check fuel pressure with a gauge.

The hose that connects the air intake box to the throttle body on a 2005 Kia Rio is the air intake hose. The air intake hose is a flexible conduit that carries air from the air intake box to the throttle body. It plays a crucial role in the proper functioning of the engine by allowing the throttle body to receive a steady supply of fresh air. This hose can become damaged or clogged over time, which can cause the engine to run poorly or stall. If the hose is damaged, it should be replaced to ensure proper engine performance.

If the white light on the lower right side of the instrument panel that normally comes on when you turn the key to start the engine is not illuminating, there may be an issue with the starting system in your 1999 Kia Sportage. Here are some steps you can take to troubleshoot the issue:

1. Check the battery: Make sure the battery is fully charged and its connections are clean and tight. If the battery is low or has a weak connection, it may not provide enough power to start the engine.
2. Check the starter: If the battery is good, check the starter. Listen for a clicking sound when you turn the key to start the engine. If you hear a clicking sound, the starter may be faulty and need to be replaced.
3. Check the ignition switch: If the battery and starter are good, the issue may be with the ignition switch. The ignition switch sends a signal to the starter to start the engine. If the switch is faulty, it may not send the signal, and the engine won't start.
4. Check the fuel system: If the engine turns over but still won't start, check the fuel system. Make sure there is fuel in the tank and check the fuel pump, fuel filter, and fuel injectors for any issues.
5. Check the spark plugs: If the fuel system is good, check the spark plugs. Remove one spark plug and check its condition. If the spark plug is worn or damaged, it may need to be replaced.

If you're unable to diagnose and fix the issue on your own, it may be best to take your Kia Sportage to a qualified mechanic or dealership for a proper diagnosis and repair.

2005 kia optima: my input shaft speed sensor located ...

https://www.justanswer.com > Car Questions Jul 27, 2010 - The input shaft speed sensor is located on top of the transmission Just under the Air Filter. So you will have to remove the Air Filter and you ... 1 answer · Top answer: Hi thank you for your question hope this helps. The input shaft speed sensor. Videos as well https://www.google.com/search?q=2005+Kia+Sedona+Location+of+input+turbine+speed+sensor+for+automatic+transmission ..

The PO420 code is a generic code indicating a problem with the catalytic converter system efficiency below threshold. This issue can be caused by several factors, including:

1. A clogged or failing catalytic converter
2. An exhaust leak before the catalytic converter
3. A malfunctioning oxygen sensor
4. Fuel system issues, such as a clogged fuel injector
5. Engine misfire
6. A damaged or failing ignition system
7. A vacuum leak

Here are the steps you can take to diagnose and fix the issue:

1. Check the catalytic converter: If the converter is clogged, it may need to be replaced.
2. Examine the exhaust system for leaks: Leaks before the catalytic converter can reduce its efficiency. If a leak is found, it should be repaired.
3. Replace the oxygen sensor: If the oxygen sensor is malfunctioning, it can cause the engine to run too rich or too lean, which can affect the catalytic converter.
4. Check the fuel system: Clogged fuel injectors can cause a lean fuel mixture, which can harm the catalytic converter. Have the fuel system checked and cleaned as necessary.
5. Repair any engine misfires: An engine misfire can damage the catalytic converter over time. Fix the misfire and see if the code returns.
6. Check the ignition system: A faulty ignition system can cause a misfire and damage the catalytic converter. Have the ignition system checked and repaired as needed.
7. Find and fix any vacuum leaks: Vacuum leaks can cause a lean fuel mixture and damage the catalytic converter.

It's best to have a mechanic diagnose the problem and perform the necessary repairs, as some of these repairs can be complicated and require specialized tools.

6mm thread is 100inch lbs max. not foot ,inch8 ft/lbs same/the service manual covers this.read it ?the ks1 pageshows"Approx. 16 ~ 28N·m(160~250 kg·cm,11.8~18.4 lb·ft)"must be 8mm thread, to be that high./same book for turboG 2.0 T-GDI THETA II shows18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

read the SM https://eautorepair.net/Marketing/Default.asp

If you have already replaced the starter and the vehicle still won't start, there are a few other things that could be causing the problem. Some possibilities include:

• A faulty ignition switch or starter relay
• A bad battery or connections
• A problem with the engine's compression
• An issue with the engine control module (ECM)
• A problem with the transmission range sensor
• An issue with the neutral safety switch

It's recommended to take your vehicle to a qualified mechanic or dealership to diagnose and fix the issue. They will be able to perform further tests and checks to determine the root cause of the problem and make the necessary repairs. Before bringing it to the mechanic, you can check the battery connections and make sure it's fully charged, also you can try to turn the key to the on position and see if any lights or sounds come on, this will give you an idea of what could be the problem.

Check the fuses covering those items.

KIA Spectra (2005-2009) fuses and relays

https://fuse-box.info > kia > kia-spectra-2005-2009-fus... Here you will find fuse box diagrams of KIA Spectra 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, ... ..

Question edited for clarity and typos. Question moved to model category. There are only three ways to get your radio. https://www.fixya.com/support/r29874205-need_vehicle_radio_code I also wrote a Tip on how to avoid this happening when you change batteries. https://www.fixya.com/cars/r29912554-changing_battery_not_create_problems ..

Yes, the code is fuel trim related, ECM is dumping fuel. The PCM may log the P0170 code for the following reasons: Contaminated Engine Oil (too long since the last oil change) A leaking injector. Aug 11, 2021

P0170 Code: Fuel Trim (Bank 1) - CarParts.com

https://www.carparts.com > blog > p0170-code-fuel-trim-...

P0170 Kia: Code Meaning, Causes, Symptoms, & Tech Notes

https://www.engine-codes.com > p0170_kia A dirty air filter, air filter housing, Mass Air Flow (MAF) sensor, or faulty MAF sensor are common causes of the P0170 code. 'What is the Cost to Diagnose the ...

If the radio worked before replacing battery and alternator, check your wiring.

WHAT LIGHT, NOT TOLD. not too many DIY swap crankshaft and when do , if done are 99% wrong, what is Bt? mean,.? post what lamp is wrong, we sure can not guess nor if engine runs last one I did I cranked the motor with fuel pump dead, (fuse pull) for good oil pressure and top end oiling all good and the run it last. or go broke fast in the business. were all bearing clearances check firsts. skip none. oops 3.

post at photo to the blind this is easy stuff but bind is 1000x too hard. lacking hands on and eyeballs on. no engine told no VIN told wow.

copy and paste https://fuse-box.info/kia/kia-optima-ms-2000-2006-fuses

READ https://eautorepair.net/Marketing/Default.asp

GOOGLE THAT YET. IF IS POSSIBLE OTHERS HAVE TOLD IT.I SEE NONE/first off the tool is mandatory to diagnose any modern and 2012 wow yes.like my jeep here it as a lame near useless cluster magic button pushes , to show DTC errors but only the USA federal codes P0nnn ,not P1, or p2 up, ever. or Unnnn or Bnnnn etc. ever.that means most are not shown there ever.why did jeep do that, well it is if stranded and in danger, say stuck in snow bank, far from any city, it might help. (YMMV) Jeep or any car that did.that is what it does, just that. it is not a scan tool periodsorry but YMMV, ask KIA that directly, OBD2 , scans lacking a tool.ask here,, on real kia forumhttps://www.kia-forums.com/search/996816/?q=can+I+see+DTC+errors+with+no+scan+tool&o=relevanceor buy one, rent one, barrow one. or get the car scanned in any shop, or at many autostores for free5 answers 1 post. a good tool is $100.less if have laptop and use thishttps://www.scantool.net/scan-tools/ all above is USA cars only, yours not toldno vin told so , answers can be wrong . lacking VIN

Yes they do Open the back trunk, look near the top of the trunk, and pull the two black levers. They have a seat folding down symbol. That will release the locks.