Kenwood Food Mixers - Page 9 - Answered Questions & Fixed Issues
I have a cream making attachment for my kenwood . how do i use it your problem?
I had one of these many years ago and, whilst I cannot remember the proportions, you warm the milk and the butter (unsalted!) very gently until the butter just melts (or melt the butter separately and add to the milk). Then put it through the machine. I seem to remember you often had to make two or three passes to get all the butter and milk to combine.I guess that the proportions of milk to butter are quite flexible depending on what sort of cream you want. I'd try small quantities till you get the required result. Start with one part butter to 2 to 4 parts milk by weight.
12/15/2011 8:07:14 PM •
Kenwood Food...
•
Answered
on Dec 15, 2011
•
323 views
Hook stuck in kenwood major;
Force it out carefully. One person wrap tea towel over hook and turn forcefully, anticlockwise. Secnd person use a long handle screwdriver to hold the Kenwood still - wedge between the housing where the hook inserts. Hold Kenwood still whilst twisting the hook. When it comes apart, clean 'hole' and hook shaft thoroughly with WD40 / oil. Might need new hook if too damaged. Ours is ok seemingly.
Can't remove beater kmix from machine. it's stuck!kenwood
Here's how to fix the stuck implement problem:The implements
each have adjustable heights. to adjust the height you need to loosen
the bolt at the top with a 14mm spanner. If the bolt was loose when it
was being used then it can get too short and not leave enough clearance
between the bolt and the machine in order to push up and turn to release
the implement. If this happens take the open ended spanner, grasp the
implement and rotate the spanner clockwise (when looking up at the
machine from below. Once the nut is loose rotate the implement until
there is enough clearance to remove it normally.
11/18/2011 8:29:30 AM •
Kenwood KM300...
•
Answered
on Nov 18, 2011
•
4,147 views
I was using the kenwood
check the plunge of the kenwood by tracing the connector wire may it remove or if not so then the kenwood has got burnt.
Kenwood_Wiring_Diagram kenwood chef A901
Hi Eward: This information is not always readilly available online. Suggest you contact Customer Support for Kenwood and inquire if they are able to make this information available.Go to the Customer Support site:
http://www.kenwoodworld.com/uk/Customer-Service/If necesary you the link to 'global site' to select your country and then scroll down and send an e-mail request to the contact name provided near the bottom of the page. Thank you for using FixYa!
Not finding what you are looking for?