I have lost my pin for my kensington bluetooth keyboard. How do I start again
Power on keyboard with 5 seconds button on. Keyboard will start with LED slow two flash mode.
Go to Device menu and "Add a device". Select Keyboard.
On the UI keyboard, input "0000" (no enter), and touch "add".
Then on the physical keyboard, input "0000" + Enter.
It should make start connecting.
The UI changes into connecting view. But it already connected.
You can test with pushing "Windows Key" on the physical keyboard.
After connected, both LED on keyboard was automatically turned off. It is still working normally.
Expert Mouse scrolling problem
I have the same problem running under win7 64 bit, I have just pulled apart my expert mouse\trackball to clean it and found that the scroll ring works by using a little infrared diode ... so no cleaning required ...
the screws for the base are located under the little rubber feet.
So I think the problem may be more related to drivers\software...
at the moment I cant find a win 64bit driver or mouse works application anywhere
My kensington trackball mouse will not work on your games.
Long ago Kensington never made the change to their driver when Microsoft went from DirectX 11 to 12
I called them and they refused to listen to me.
Very poor caliper of people in charge there.
Shame as the Trackball is a very good alternative to both the mouse and a joystick.
If they would update the driver then the trackball maybe a popular way to play games
The only way you can get it to work is to plugin another mouse
It will then work with all games
Need to know power requirements for the kensington k33141 usb hub
hello,
i believe i know the answer. i have the kensington pocket hub se 2.0 model: k33141. it seemed to work with the adapter i found in our closet. it is a dve Model : dsa-0131f-05 us 13 and it outputs 5v 2.5a. the adapter has a thin profiile like it would be plugged into a strip. and it has an rf blocker which suggests computer equipment.
Kensington 64213 Expert Pro Mouse poor tracking
Cause:
I found the cause and solution. Dust and debris settle in the up and down roller more so than the side to side roller because of the angle and gravity.
Solution:
You need to take apart the plastic housing and then dismantle the circuit board to get in and remove dust/debris from the up and down roller area. You will need a magnifying glass and small flash light to really inspect the area. I took a sewing needle and carefully removed all the debris on both sides of this roller. I then blew the area clean with my mouth. You should actually use a compressed air spray from an electronics store. After removing all the debris and air spraying it clean then assemble back to normal the circuit board and housing. Bingo! This solved the problem which is not an electronic problem but a mechanical one.
Not finding what you are looking for?
