Kenmore Cooktops - Page 3 - Recent Questions, Troubleshooting & Support

Model number will be located on the data tag. This will be on the back or perhaps inside the over door area.

Check fuses and control.

Faulty control behind knob

Voltage check at plug or power panel

Locked cook-top? Check breaker, fuses, plug

Fuse or control

Do you mean safety light to let you know burner is hot?????

Probably couple of hundred dollars installed. Might be time to replace stove!!

If element caught on fire, I would suspect stove needs cleaning. Do that then elements should not smoke for long. (I hope all moisture was removed from stove!!!)

Usually you can copy wiring from other element. Safest to consult wiring diagram found inside control panel.

Check fuses. Burners are usually fused in pairs. Probably 2 fuses since 220V.(one for each 110 side of feed).

Shorted control behind knob. Temporary fix: remove fuses for that element

Razor blade paint scraper at 45 degree angle, then use non-metallic dish scrubber with stove top cleaning product.

You could try to restart and stop clean cycle. Otherwise unplug stove and remove back panel to access locking mechanism.

Control behind knob needs replacing.

Normally if a burner burned out and or shorted, it would burn a fuse rather than kick out the breaker.

4. But there is more to it than that. Dryers have 30 amp, ranges 40-50amp plugs both of which are 4 pin with different shapes.