Do some gave the instruction manual for the Kelvinator FD830 Freezer. I am not sure how to set the temp on it?
Locate the Temperature Control Knob: The temperature control knob is typically located inside the freezer compartment. It allows you to adjust the temperature settings.
Understanding the Knob:
For Top Mount ™ Models: The temperature control knob is usually located in the refrigerator section. At higher altitudes (e.g., 1000 meters above sea level), set the refrigerator temperature control to one-half setting warmer than MID.
For Bottom Mount (BM) Models: Adjust the refrigerator temperature using the bottom knob.
Setting the Temperature:
Turn the knob clockwise (usually towards the "colder" side) to lower the temperature.
Turn the knob counterclockwise (towards the "warmer" side) to raise the temperature.
Adjusting the fridge compartment temperature may cause a small change in the freezer temperature.
Remember to allow some clearance around the freezer for proper ventilation.
My dishwasher do not stop at the end of a cycle, it carries on with the next cycle
If your Kelvinator dishwasher is not stopping at the end of a cycle and carrying on with the next cycle, there could be a few different reasons. Here are a few things you can try to troubleshoot the problem:
- Check the timer: Make sure that the timer is set correctly and that it is not stuck in a continuous loop.
- Check the control board: Make sure that the control board is not malfunctioning.
- Check the water level sensor: Make sure that the water level sensor is not clogged or malfunctioning.
- Check the door switch: Make sure that the door switch is not stuck in the closed position.
- Check the wash impeller: Make sure that the wash impeller is not clogged or malfunctioning.
- Check the wash motor: Make sure that the wash motor is not malfunctioning.
- Contact Kelvinator customer support: If you have tried all the above steps and the dishwasher is still not working, it may be best to contact Kelvinator customer support for further assistance. They will be able to diagnose and fix the issue, or tell you if a repair is needed.
Not finding what you are looking for?