Keeway Logo

Keeway Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 106 Products
  • 392 Answers
  • 61K Views

Hi, Adam for more information about your question and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
Thread Larger fellow looking for help
Newbie Keeway TX125 any good
De restrict Keeway Matrix and Act
https://scootergrisen.dk/scooterhjemmeside/download/keeway_focus_matrix_servicemanual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2010 Keeway... | Answered on Mar 23, 2016


Hi, Make for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary, transport your bike to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your problem. For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.
KEEWAY SUPERLIGHT 125 150 SCOOTER SERVICE REPAIR MANUAL 2006 2012 Download...
Quality Replacement Parts For Keeway
Keeway Speed 125 Parts
Keeway Speed 125 2010

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2010 Keeway... | Answered on Mar 01, 2016


Hi, Brandon the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or damaged battery, 9 volts or lower.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. Gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable free downloads that you need please visit the websites below. Good luck and have a nice day.
50cc keeway hurricane problems
Help Scooter won start cleaned carb which hoses
Scooter Troubleshooting Scooter won start All about Scooters
http://www.49ccscoot.com/manuals/Keeway_50cc_2T_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Keeway... | Answered on Feb 22, 2016


Hi, Ben as long as they are securely fastened and fit and safe. Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Keeway... | Answered on Feb 06, 2016


Hi, Anonymous as long as the parts fit securely and are safe and functional sure why not. Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Keeway... | Answered on Feb 06, 2016


Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary, transport your bike to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your problem. Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Keeway... | Answered on Feb 06, 2016


Hi, Semso and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition and leaking.
3. Spark plug gap too close or too wide.
4. Faulty ignition coil, module, and or sensor.
5. Battery nearly discharged.
6. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
7. Intake air leak.
8. Water, dirt, or rust in the fuel system, carburetor and/or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor.
12. Loose, dirty, or corroded ignition module connector at crankcase.
13. Faulty MAP, CKP, O2, and/or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damaged intake or exhaust valve.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
Motorcycle Carburetor Cleaning and Rebuild part 1
Troubleshooting Motorcycle Ignition 1982 Yamaha xj550 maxim http://www.49ccscoot.com/manuals/Keeway_50cc_2T_Service_Manual.pdf
http://absolutelyscooters.net/service-manuals.html

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e



Keeway... | Answered on Dec 19, 2015


Hi, Anonymous probably so for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.
http://www.49ccscoot.com/manuals/Keeway_50cc_2T_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2010 Keeway... | Answered on Nov 19, 2015


Hi, Dovydoo for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Keeway... | Answered on Nov 12, 2015


Hi, Callum and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2006 Keeway... | Answered on Nov 11, 2015


please clarify your question,my psychic abilities are failing me

Keeway... | Answered on Oct 18, 2015


I am Graham from Devon

Keeway... | Answered on Oct 16, 2015


Hi Alan, for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix/test or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Keeway... | Answered on Oct 16, 2015


Hi Rileyluhpink, for more information about your question please visit the website below. Good luck and have a nice day.
http://www.49ccscoot.com/manuals/Keeway_50cc_2T_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2010 Keeway... | Answered on Oct 04, 2015


Hi Kiminmiami, for more information about your question please visit the website below. Good luck and have a nice day
.http://www.49ccscoot.com/manuals/Keeway_50cc_2T_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2008 Keeway... | Answered on Sep 30, 2015


IS THE SPARK PLUG WIRE CONNECTED?

Keeway... | Answered on Sep 01, 2015


CHECK VOLTAGE WITH VOLT METER AND GAS/OIL MIX COULD BE RUNNING ROUGH

2006 Keeway... | Answered on Jul 05, 2015


it takes a 428 chain ,im not sure how long but get. 120 links and cut it down if you need to.

Keeway... | Answered on May 09, 2015

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Keeway Experts

Marvin
Marvin

Level 3 Expert

84540 Answers

richard libby

Level 2 Expert

202 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5821 Answers

Are you a Keeway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...