Kaz Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 49 Products
  • 109 Answers
  • 16K Views

Steam generating elements defective

Kaz Humidifiers | 527 views | 0 helpful votes


Request specifications for model 101directly from Kaz.

Kaz Humidifiers | 152 views | 0 helpful votes


May have damaged the ultrasonic transmitter when it hit the floor, There is likely no parts available to repair it.

Kaz 5520B... | 322 views | 0 helpful votes


You can download the manual here... http://www.manualslib.com/manual/706474/Vicks-V4450.html

Kaz V4500... | 317 views | 0 helpful votes


I think that depends on how strong your microwave is. A safe bet would be to microwave it in thirty second intervals until you get the right temperature. I have a relatively weak microwave and I need to heat mine up for about two minutes.

Kaz SoftHeat... | 50 views | 0 helpful votes


Power supply failed. You need to replace it.

Kaz Hfd-130... | 102 views | 1 helpful votes


Typically, for anything, I try 15 seconds (below 100g ), if not sufficient 30 seconds and progressively more as function of weight ( one to two minutes for 300g) , testing the not burning temperature with your hand.

It is very burning to try several minutes abruptly without testing progressively. You can even have explosions, in particular with eggs !!

Kaz SoftHeat... | 51 views | 0 helpful votes


If this is a unit that has been used for some period of time,it may be clogged and in need of cleaning

Kaz inc v3500-n... | 101 views | 1 helpful votes


Fill it to the fill line on the side.

Kaz 4100 Cool... | 37 views | 0 helpful votes


Cut and paste the below URL into your address bar.  Select you model and download the manual.

 

http://www.coldandflushop.com/cold-flu/customer-support/product-manuals/

Kaz V4500... | 352 views | 0 helpful votes


http://www.honeywellpurifiers.com/ssi/pdf/honeywell/50100-200-300-manual.pdf


The Intelli-Check™ Filter Monitors will indicate replacement of the pre-filter and the

HEPA filter. Depending upon your individual usage (environment and hours used),

you may need to check and replace the filters more or less frequently.

To check Expected Filter Life Usage

When the unit is turned on, quickly press the appropriate filter monitor button. The

pre-filter light will flash up to 3 times and the HEPA filter light will flash up to 4 times,

depending upon how much expected filter life has been used.

PREFILTER:

1 flash = from new, up to 1/3 expected life used up

2 flashes = between 1/3 and 2/3 expected life used up

3 flashes = between 2/3 and all of expected life used up

Remains on = time to check/replace pre-filter

HEPA FILTER:

1 flash = from new, up to 1/4 expected life used up

2 flashes = between 1/4 and 1/2 expected life used up

3 flashes = between 1/2 and 3/4 expected life used up

4 flashes = between 3/4 and all of expected life used up

Remains on = time to check/replace HEPA filter

To RESET Filter Monitor

When the filter monitor light remains on, it is time to check/replace the filter and reset

the filter monitor, if needed. With the unit powered on, press and hold the appropriate

filter monitor button down for approximately 5 seconds until the light turns off.
Depending upon your individual usage (environment and hours
Page 6:

Kaz Honeywell... | 1,044 views | 0 helpful votes


The outside you can clean with warm soapy water. The inside can be flushed with a 50/50 solution of White Vinegar and Bottled Distilled Water. Fill the tank and run the unit until the tank is almost empty. Pour out the remaining solution and fill the tank with more of the Bottled Distilled Water. Operate the unit for 30 minutes and the previous solution should have been flushed out by then. I would recommend using Bottled Distilled Water all the time rather than tap water. As tap water has a lot of minerals in it that can cause calcium scale and clog the unit.

Hope this helped you.

Kaz Sesame... | 240 views | 2 helpful votes


http://www.ehow.com/how_7442829_clean-vicks-humidifier-model-v4450.html

Kaz V4500... | 1,639 views | 1 helpful votes


Chances are the rubber pump inside the unit cracked and will not work anymore. This type of unit is a "Disposable" unit and is not intended for repairs. Its cheaper to buy a new one then buy parts for this.
Hope it helps.

Kaz 2200-6 2... | 239 views | 0 helpful votes


If you've been using tap water, then you likely have hard water deposits (scale) on the heating element, which will eventually cause it to stop working. Try cleaning it with an overnight vinegar soak, or whatever is suggested in the manual if you have one. Once most of the deposits are gone, it shold work again. In the future, this will not happen if you use distilled (not to be confused with filtered) water. Good luck!

Kaz 4100 1... | 110 views | 0 helpful votes


How do I clean white gritty minerals from under plastic wheel. I took out the three screws, but the wheel will not move. I'm afraid to force it...might crack or break.

Kaz 4100 1... | 93 views | 0 helpful votes


I want to clean the white gritty minerals from the fly wheel inside the humidifier. I took the three screws out but the plastic wheel will not move. I'm afraid to force it...might crack or break.

Kaz 4100 1... | 224 views | 0 helpful votes


you have to pop the cover off of the top if there are not screws holding the cover on then it should pop off with a screwdriver or you can use compressed air in a can that they sell in stores for cleaning computers

Kaz 3300... | 342 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kaz Experts

Brad Brown

Level 3 Expert

18031 Answers

Tom Chichester

Level 3 Expert

51311 Answers

ray gallant
ray gallant

Level 3 Expert

61734 Answers

Are you a Kaz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...