Kaz Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 49 Products
  • 109 Answers
  • 16K Views

The light itself is likely bright enough to trip the photo cell back off. Rinse and repeat...

Kaz Home... | Answered on Jan 01, 2011


you have to pop the cover off of the top if there are not screws holding the cover on then it should pop off with a screwdriver or you can use compressed air in a can that they sell in stores for cleaning computers

Kaz 3300... | Answered on Nov 20, 2010


When the filter monitor light remains on, it is time to check/clean the IFD™ filters and reset the filter
monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED
filter check light and hold for approximately 5 seconds until the light turns off (Fig. 3). Depending upon
your individual usage (environment and hours used), you may need to check and clean the filters more or
less frequently. If the IFD™ filters are cleaned before the filter monitor light turns on, the filter monitor
should be reset at the same time.

Kaz Honeywell... | Answered on Nov 07, 2010


Hello,

Check to see if there is power getting to your device. If it is a 110-volt unit, plug a lamp or other device into the same outlet the device is plugged into. If there's no power, check the fuses or circuit breakers. If there's still no power, you will need to contact a qualified electrician to restore power to the outlet. If there is power to the appliance but it is still completely dead there may be a problem in one or more of the following areas: Wiring (Inspect for any broken or burnt wiring) Selector switch Control board Work on these areas of an appliance may require help from an appliance repair person or other qualified technician.
Take care.

Kaz Air... | Answered on Oct 10, 2010


their may be a reset button on the cord where it plugs into the outlet .check this ..let me know ..good luck/joe

Kaz Honeywell... | Answered on Aug 30, 2010


Hi,
the humidistat or sensor has gone bad...

heatman101

Kaz... | Answered on Aug 29, 2010


We have had a separate make for years and just use tap with no problems.It leaves a water mark on the water holder but it cleans off.If you have a water filter already on your tap or a Brita type container with a filter,feel free to use that too.Either way,it will not hurt the humidifier. Good luck! Greg

Kaz 4100 1... | Answered on Aug 13, 2010


how do i use the health mist humidifier

Kaz 3300... | Answered on Apr 19, 2010


I would try magic puddy. they sell it at bed bath and beyond, with coupon you can get this for like 8 bucks. this puddy is the best epoxy i ever used. i put this on water tanks, refrigerators, anything that leaks, gas, water, freon and it worked really well. you get 3 stciks so it will last you for other applications. make sure you are wearing latex gloves cause this stuff will stay on your fingers for a bit. hard to clean off

Kaz 5520B... | Answered on Mar 21, 2010


If it will plug into standard wall socket it is 110 volts. 240 volt plug is different

Kaz 4100 1... | Answered on Jan 27, 2010


Suspect that you may need to run white vingar through it and clear the atomizer. You should see mist all the time even when the humidity level is reached.

Kaz 4100 1... | Answered on Jan 15, 2010


If there is not much leftover water, you don't have to worry much about it. However, if the leftover water is
somewhat flooding the area where it was located, it is a
different story, there is a leak and it must be corrected.
Check for leaks in the water container, so that operates
normally. Hope this will help you.

Kaz 5520B... | Answered on Jan 10, 2010


fill with water - the water conducts electricity and in a few minutes will produce steam

Kaz Vicks... | Answered on Jan 06, 2010

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kaz Experts

Brad Brown

Level 3 Expert

18031 Answers

Tom Chichester

Level 3 Expert

51311 Answers

ray gallant
ray gallant

Level 3 Expert

61734 Answers

Are you a Kaz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...