Its leaking water
Take it out of case
Connect to hose. Turn on tap & see were the leek is.
The car would not go into gear
if this is a new clutch kit that has been put in then it is more than likely that the clutch plate has been install incorrectly and the hub is hitting on the flywheel bolts
If it not a new kit then the clutch system is at fault hydraulic or cable
It keeps dying even after being charged.
You need a new battery. I could describe how to rebuild the old one if you are so inclined to do that type of thing. It would save you some money over buying a new one. It looks like it is a specialized piece of cleaning equipment and buying a replacement battery would be fairly expensive.
What can cause my kercher 380 to just stop?
If the unit has seen a few tens of hours of work, it may be the brushes. My unit was going fine, then for a minute or 2, it was like someone was winding the inlet power down then back up. Then it stopped and would not start. I replaced the brushes and it now runs as it did. Several 10's of hours old, but not ready for the scrap pile yet.
When turned on blowing fuses
Short circuit inside machine. In a device typically resulting from the unintended contact of components and consequent accidental diversion of the current.
Not finding what you are looking for?