Fill water tank
small float in tank stuck in down position. remove tank and clean with hot water. rinse the give a good shake you will hear float rattle in tank
Tray missing error
The "sensor" is most likely a micro-switch. When the tray is in it actuates the switch and closes a circuit indicating to the controller that the tray is in place. Sorry to tell you this but it will have to be disassembled to replace the switch if it has failed as the micro-switches are usually sealed items that are not normally cleaned.
Empty Tray
Hi all, I have the exactly same problem on my Gaggenau CM470 however the drip tray is clean and the contacts in the back is also 100% clean.. I wonder if its possible to disable the sensor/switch on a CM470 ?
Just got a Jura x5 from a friend who has not used
Message :Fill SystemCauses/Troubleshooting:Leaks in the fluid system-localize the leaks and seal them.Blockage in the fluid system, no water can be fed - Localize blockage and replace blocked components (valves, heater, tubes) if necessary.Flow meter-count error - Open the floow meter by a quarter turn and clean it, replace if necessary.
The grounds container in my Jura Ena4 is jammed.
On the A1 there is a sensor on the bottom edge of the panel showing the help phone numbers. On other models it may be located behind where the trip tray would be inserted. The sensor detects the presence of the grounds container. Take a paper clip and push up inside the notch holding the sensor. Do this with the machine on. The flap will be withdrawn and everything will fit back in.
Press steam fill water
You can check the water valve, it may become clogged. But you should not disassemble machine if you are not specialist. Contact Jura service center if your machine still under warranty.
Malfunction
Error 1 is a defect in the steam heating unit.Possible solutions:Thermal sensor is defective -replace.Cable to the thermal is broken or contact pins are corroded - replace, repair.Heating or thermal cut-out are defective - measure and replace parts if required.Triac on the power board is defective. The heater heats up triggering the overtemperature protection - Replace the overtempereature protection (thermal cut out) and the power board or the single triac.
Service manual cva620
http://elektrotanya.com/miele_cva620.rar/download.html
Try there
All the best
Kolbrun
What is an error code E5 mean?
Error code 5 means : Required temperature not reached.Causes/TrubleshootingThermoblock has blown - replace thermoblock.Power electronics is defective - replace the triacs of the power board or the whole power board.Attention - determine resistance value of the Thermoblock to avoid subsequent errors.
This coffee maker starts brewing when I pour water
Not the best solution, but you could unplug it before you put the water in. Also, maybe check the user guide and make sure you haven't accidentally change the way it brews. There may be an "Instant" brew setting you didn't realized got set.
Not finding what you are looking for?