Error report fill water tank
small black rectangular float is stuck in the water tanks . take off tank and empty. then shake you will see it on the side wall (machine side) if it does not rise when water is filled the machine still thinks its empty
The coffee is not coming out of the coffee spout
I had a similar problem. I always religiously cleaned the machine when prompted but nonetheless I reached a point where coffee quit coming out of one nozzle. I tried the suggestion to stick a wire up the nozzle to dislodge any residue that was blocking the water. That helped a little and then it did not next time. So I USED A DENTAL WATER PICK on both nozzles and that cleared up the problem completely. MUCH BETTER than wire or paperclip.
CoffeeTEAM TS leaks water
Hello, what I have found is the most common cause of water leaking out of the bottom of the capresso team coffee maker is a leaking silicone hose that runs to the boiler (see the photo below showing the split in the hose). The replacement silicone hose needs to be safe for beverage dispensing, food & dairy processing, taste and odor-free, with a temperature range of -75? to 350? F. All you need is a sharp pick, a phillips screwdriver, and a pair of needle nose pliers. Remove the four rubber pads on the bottom using the pick. Use the screwdriver to remove the six screws holding the bottom plate on. Remove and replace
"BOTH" hoses using the needlenose pliers to pinch the hose clamps. Better to play it safe while you have it apart. If one is bad the other is likely not far behind. I hope this helps.
I took everything apart to give it a good cleaning and now all settings produce a very fine grind. Any thoughts?
I had the same problem with too fine a grind when I took mine completely apart to clean (including the lower burr). The solution I finally came around to was to further tighten the star-shaped screw which holds the lower burr assembly in place. I had originally just tightened it until the lower burr until the lower burr assembly started to turn with the screw, but that wasn't enough. So I held the assembly in place and tightened the screw further and I'm back to my previous grind coarseness/fineness.
Xs90 stuck heating up
constant heating message on screen is from a thermal fuse blown on one of the boilers. service call required i'm afraid...... very cheap part about 10 euro
Error report fill water
remove tank clean with hot water, rinse and shake you should hear a rattle in the bottom of the tank. if you dont the the small black float built into the tank side wall is stuck. once free it will work fine.
No power
if the hopper is not sitting properly it will not turn on. there is a small micro switch on the top part of the machine which is activated by one of the upper lids
Error 8
use distiled water and vinegar to descale
Not brewing coffee or rinsing
I don't know. Maybe you should just buy a new one? But if it's like SUPER expensive, I don't know. :L eh. I'm just a 12 year old girl.
The flap will not go all the way up so the drawer can go all the way in
This one is easy. Remove the tray then unplug the machine. Wait a full five minutes then put then put the tray back In WITHOUT the box. Plug it back in. It will recycle and the flap will behave again. FYI make sure that each time you remove the grounds you find the screen behind and above the flap and clean it with a wet paper towel. It's the size of a nickle and gets clogged if you don't do this.
Parts breakout
i have uploaded the parts breakout under the "guides" section
Leaking steam valve
Jura are a top brand and offer service and repair on their machines. Ask your local Jura dealer for a repair estimate.
Not finding what you are looking for?