Our company has started manufacturing
Make up a way to blow warm air from the condenser over the glass and your frost problem will disappear! The higher the temperature of the air - the more moisture it can absorb. The reason you are having the problem is that you are cooling moisture laden air and it has to give up the moisture as you cool it. So run some warm air over it and it will absorb the moisture for you = problem gone.
koolman77 (refrigeration technician)
We have a model F-18
www.jet-tech.com/products/F-18DP/f18_tech_manual.pdf
Copy and paste that link into your internet address bar or type it in.
That is your manual
Please help me, I need
YOur best bet is still the electrician.
However, I would get him to go through the electric diagrams contained in
this website. Scroll down to the F-22 model. He will need to check if the model is single or 3 phase mains. It is likely the Earth connection has come loose.
Once you get him there he can also call Jet Tech support (see the phone no. on the website) explaining the problem. They are based in Canada but have a toll free support line.
I hope this helps and you can get back to operations soon. It must be a big inconvenience to your business not being able to get the dishes washed.
Please rate the solution if this helps.
Drain pipe broken
If this is a common problem then ring the manufacturer, if not you will need to have it replaced.
The Dish Washer is Not Hot enough
If an adjustable thermostat is provided adjust the dial. If it is an electronic type, check the sensor with a correct part no.
Refer user guide also for the adjustments.
Water to dishwasher not hot enough
The 737 model could run on even lower temperature (80F). Given time, the unit will heat up the water. the trick is to give it time.
That model is made for commercial use, not really for residential. It will not fully drain every cycles. The important thing to keep in mind is to empty the dishwasher (turn it off, pull the stand-pipe out, and drain) every night and left empty. When you want to use the unit, put the plug back in and turn it on, wait 20 to 30 minutes and it should be ready.
Robert Marsolais
Jet tech washer 737 dp
Ouch.
Before you start changing all sort of parts, correct your problem with the wires. You may have to change most of them, depending on how bad the chemical burned tru them.
A good cleaning is required because that soap is going to continue chewing on those wires.
You're right about a short causing other component failure. But first repair those wires
Robert Marsolais
Water temperature is not hot enough
the heater in the unit is supposed to heat both the wash water and the rinse water.
if it is not, then you have a problem in a controller or an element.
how are you determining the temperature and are you waiting for the unit to signal ready before you test it?
mark evans
[email protected]
Not finding what you are looking for?