Drain pipe broken
If this is a common problem then ring the manufacturer, if not you will need to have it replaced.
The Dish Washer is Not Hot enough
If an adjustable thermostat is provided adjust the dial. If it is an electronic type, check the sensor with a correct part no.
Refer user guide also for the adjustments.
Jet tech washer 737 dp
Ouch.
Before you start changing all sort of parts, correct your problem with the wires. You may have to change most of them, depending on how bad the chemical burned tru them.
A good cleaning is required because that soap is going to continue chewing on those wires.
You're right about a short causing other component failure. But first repair those wires
Robert Marsolais
Water to dishwasher not hot enough
The 737 model could run on even lower temperature (80F). Given time, the unit will heat up the water. the trick is to give it time.
That model is made for commercial use, not really for residential. It will not fully drain every cycles. The important thing to keep in mind is to empty the dishwasher (turn it off, pull the stand-pipe out, and drain) every night and left empty. When you want to use the unit, put the plug back in and turn it on, wait 20 to 30 minutes and it should be ready.
Robert Marsolais
Water temperature is not hot enough
the heater in the unit is supposed to heat both the wash water and the rinse water.
if it is not, then you have a problem in a controller or an element.
how are you determining the temperature and are you waiting for the unit to signal ready before you test it?
mark evans
[email protected]
Not finding what you are looking for?
