How do I change the in-line fuse on the Jet 3 ( not ultra)
the 7.5 amp fuse is for the controller power. The power chair inline fuse is either a 40~50 amp circuit breaker, a fuse link or a fuse. If any of these fuses are bad, then you will not have power. Remember that if the fuse is blown there is a problem, you need to get it checked out by a tech. A blown fuse usually alerts you of a bigger problem.
My chair will not turn on after I unplug it from the wall. Batteries test good
I have the same model and had a problem,very much like yours,so I got the local (Parramatta NSW Australia) to call and he found some corrosion and general dirt in the control arm electeical connections .......... took an hour or so to fix and all is OK now.
Mind you it was/is still in warranty so no charge applied.
Joe
How do i adjust the blade tilt
There should be 2 handles: height and tilt. Tilt is typically located perpendicular to the blade on the base of the saw.
12/28/2014 10:28:29 PM •
Jet Saws
•
168 views • 0 helpful votes
How do I clean my SATA Jet NR2000?
take apart the spray nozzle and needle and soak in laquer thinner overnight take a gun brush clean all parts and reassemble try spraying some clean thinner through it and check your pattern
Wiring diagram
rear battery wire connects to positive red terminal,then rear battery to negative black terminal,battery terminals facing inward,front battery to other batterys positive red cable ,wire labeled front battery to black negative cable,plug wire harness into quick disconnect...page 40 of owners manual
Not finding what you are looking for?