Jet Health & Beauty - Popular Questions, Answers, Tips & Manuals

All questions need 'make model (what it is)' please. The appears to be a 24 volt charger for a Pride Mobility Scooter. You just need the manual for the Scooter really. https://www.google.com/search?q=jet+charger+2904jt-24+manual ..

Question edited for clarity. You have a dead short somewhere. You need some electrical knowledge and a digital multimeter for testing. Take all the covers off. Look for wiring that has rubbed through and touching or melted. Disconnect one of the motors and replace the fuse. If it still blows, reconnect that one and disconnect the other motor. If one motor doesn't blow and the other does, you know you have a faulty motor. If neither stop the issue, then you move up to the controller and look up there. With a meter you can check for shorts within the motors, as well as grounds. Or just take it to a Service Centre and have it repaired and serviced properly. Basic troubleshooting

INFINFB2045 Jet 3 Ultra Troubleshooting

Pride Mobility https://www.pridemobility.com > pdf > infinfb2... PDF troubleshooting instructions for the Jet 3 Ultra Power Chair. This information is to be ... A blown charger fuse can cause the charger inhibit to activate.

• JET 3 ULTRA

  https://www.pridemobility.com > pdf > us_jazzy PDF Jet 3 Ultra www.pridemobility.com. 3 ... If the circuit trips, allow your power chair to "rest" for approximately one minute. ... thermal fuse on each lead.

INFINFB2045 Jet 3 Ultra Troubleshooting https://www.pridemobility.com/.../troubleshooting/infinfb2045_jet_3_ultra_ troubleshooting.pdf File Format: PDF/Adobe Acrobat troubleshooting instructions for the Jet 3 Ultra Power Chair. ... What if the systems on my Jet 3 Ultra seem to be "dead" (controller does not light up when the on/off key is ... you continually allow the battery condition meter LEDs to fall into the red area, the ... 1 Flash. The batteries need charging. Check the battery connections.

Hi u cant rely on battery voltage it won'tell u the condition of the batteries.... The BATTERY'S HAVE TO B LOAD TESTED ONE AT A TIME WITH A 12 VOLT LOAD TESTER AVAILABLE ON E/BAY COST APROX $30 THIS WILL GIVE U A GOOD INDICATION ON THERE CONDITION....cheers

They run the pump that sprays the cleaning solution.

Yes the batteries are defective.

Hi if u have 2 x 12 volt batteries connected in series :::: this bring the voltage up to 24 volts u can use it ..cheers

https://www.manualslib.com/j/jet+3+ultra.html Results 1 20 of 20

I DONT THINK SO.....READ THE PACKAGING LABEL.

you will need a off-board charger to charge the chair Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

If the charger is unplugged and the freewheel levers are in drive position. The joystick should not have any flash lights on it, this indicates a flash code that needs to be addressed. If the lights are rippling up and down it could be locked out. some joysticks can be reset by pushing the horn button twice after turning it on within 10 sec.some are reset by pushing joystick forward until it beeps then back til it beeps this done right after startup also. otherwise there maybe something more serious going on with the chair. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

if it has four posts you will have to release each of the front latches and tilt back the seat, watchout it may not be hinged . Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

Hi there is one on E/BAY .US $49-99 cheers

because one battery may have a mechanical failure inside and the other side is ok. you will want to replace the batteries as a pair. I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

http://www.pridemobility.com/pdf/owners_manuals/us_jazzy/us_jet_3_ultra_om.pdf Here's the manual for the chair.

All the battery lights should be on and the yellow speed control should not be blinking. a flashing red indicates charging is needed. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

That is a trip code count how many flashes and lights are lit at the flashing I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

make sure batteries are connected correctly and the connections are good. I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

Talk to the maker of the chair, you'll probably need to replace the speed controller. You'll need the make, model and serial number of the chair when you contact them.

The Pride Mobility Net 3 ultra has a 3 amp off board charger looks like this and can be purchased from Monster Scooter parts. It plugs into the front of the joystick.http://www.monsterscooterparts.com/24-volt-3-amp-xlr-battery-charger-upg.html