Jet Health & Beauty - Page 9 - Recent Questions, Troubleshooting & Support
INVAMED SCOOTER IS RUNNING SLOW
Check condition of batteries. Be sure casters and anti-tilt wheels are turning freely. Be sure speed control buttons on keypad are free of crud and are advancing the LEDs.
How to replace replace wheel bearings
Make, model??? Since I don't know the model: wheels normally slide onto the gearbox shaft key and is held in place with a nut and washer at the end of the shaft, The bearings are located on the drive shaft, inside the gearbox housing, next to the wheel assembly. They are usually pressed on and requires disassembly to press them off and replaced.
How to tell if it is charging
The Jet3 Ultra has an amp meter built in. Remove the rubber cover on the right side behind the wheel and see if the needle is moving.
It wont start
Since you left no details I will suggest that you determine the condition of your batteries and go from there.
Flashing light
What set of lights are flashing, what color are they, do they flash all together or ripple left to right one at a time? Could be a low battery, the GC is in Lock Mode, etc. If the GC is in Lock Mode push the joystick forward until it beeps and then pull it back until it beeps. Release it and the controller will sound a long beep. Charging takes many hours on these power chairs.
Oil leakage in pronto power wheelchair
if the leak is by 1 of the wheels it could be the seal at the drive out put ,if you can't find a seal it could be gotten from a bearing supplier ,it would need to be matched
Changing battery or is it batteries
lots of questions how old is chair, how old is batteries, it has 2 by the way 12v connected in series giving 24v , always change both not just one, check for loose connections first and be sure charger is good try on another chair and/or try another charger on yours if possible they are 95% interchangeable
Not finding what you are looking for?