Jet Health & Beauty - Page 4 - Recent Questions, Troubleshooting & Support

0helpful
1answer

How to change wheelchair battery

Some you take off the front section and some you will need to remove the seat to gain access to the batteries Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:18:53 PM • Jet Health &... • Answered on Oct 10, 2017
0helpful
1answer

Blinking light

You may have a lockout problem. push on power button then push the horn twice to reset the lock. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:17:10 PM • Jet 3 Ultra... • Answered on Oct 10, 2017
0helpful
1answer

Losing charge

I think the charger maybe dieing part way through the charging cycle, have charger checked. the charging cycle should be about 10-14 hours! Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:15:03 PM • Jet 3 Ultra... • Answered on Oct 10, 2017
0helpful
1answer

My levo power wheel chair displays pm module error with code 3100

Call the Levo Techs and ask them. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:12:48 PM • Jet Health &... • Answered on Oct 10, 2017
0helpful
1answer

Blinking red light no power new batterys

Needs charging Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:11:29 PM • Jet 3 Ultra... • Answered on Oct 10, 2017
0helpful
1answer

How do u fix a pronto m51 wheel chair joystick after it got wet and it flashes 7 times

I would dry it completely and try it again. it may need to be opened and dried on the inside, or replace the joystick. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:10:10 PM • Jet 3 Ultra... • Answered on Oct 10, 2017
0helpful
1answer

How to reprogram a jet 3 ultra joystick

Hire a Technician with a programmer to adjust the program for you.email me if you need help getting a technician I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:07:32 PM • Jet 3 Ultra... • Answered on Oct 10, 2017
0helpful
1answer

When I engage joystick the break release clicks a second apart instead of both at same time. any advice appreciated.

Have the Brakes checked, wiring, and ohm the coil to see if they are about the same. wiring could be loose. Problem maybe in the controller, but better to check the wires first. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 6:05:10 PM • Jet 3 Ultra... • Answered on Oct 10, 2017
0helpful
1answer

Why wont my jet 1 powerchair move with fully charged batterys

If the charger is unplugged and the freewheel levers are in drive position. The joystick should not have any flash lights on it, this indicates a flash code that needs to be addressed. If the lights are rippling up and down it could be locked out. some joysticks can be reset by pushing the horn button twice after turning it on within 10 sec.some are reset by pushing joystick forward until it beeps then back til it beeps this done right after startup also. otherwise there maybe something more serious going on with the chair. Strege Mobility I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
10/10/2017 5:45:47 PM • Jet Health &... • Answered on Oct 10, 2017
0helpful
1answer

Trying to find the site to go to to buy Jet Jat Ultra drone for $49.99. Heard about it on Extra Pop Up Shop.

Hi there is one on E/BAY .US $49-99 cheers
6/4/2017 12:45:52 PM • Jet Health &... • Answered on Jun 04, 2017
0helpful
1answer

Why isn't chair charging?

1. Make sure that your chair is turned on. 2. Make sure that the brake release levers are in the drive position. See owner's manual. 3. Make sure that your chair is charged. 4. Make sure that your chair is not plugged into the wall.
4/25/2017 6:56:22 AM • Jet 3 Ultra... • Answered on Apr 25, 2017
0helpful
1answer

Failure to power on

Check freewheel levers are in drive position. Controller maybe bad. I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489
3/15/2017 9:05:54 PM • Jet 3 Ultra... • Answered on Mar 15, 2017
0helpful
1answer

Speed control won't work. stays on high. cannot adjust.

Talk to the maker of the chair, you'll probably need to replace the speed controller. You'll need the make, model and serial number of the chair when you contact them.
8/7/2016 3:56:22 AM • Jet 3 Ultra... • Answered on Aug 07, 2016
Not finding what you are looking for?
Jet Logo

465 questions posted

Ask a Question

Usually answered in minutes!

Top Jet Health & Beauty Experts

ADMIN Eric
ADMIN Eric

Level 3 Expert

39363 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66855 Answers

Are you a Jet Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...