Jensen Recent Questions, Troubleshooting Help & Support

QUICK SEARCH
Turn device on
Press and hold [SET] button, then press and release DEVICE button eg tv, vcr , sat, aux
release [set] point the remote at device and pres [POWER] or [PLAY]
until device turns off or plays
Press [ DEVICE] to lock up the code
check other buttons

They make a special spray for that purpose.

You need to contact Jensen product support website.

Sorry we are not a part seller or locator.

I need more info. Did you check the ground wire to make sure you have a good ground? Some installers try to rely on the antenna for a ground when hooking it up due to laziness and it will eventually burn the stereo out from low voltage, or, you could have amps that are killing the battery enough to drop the voltage down and it's killing the stereo. I have also seen ground loops kill stereos, but, I need a bit clearer info as to exactly whats happening to answer the question.

Rca jacks either are lose or either one burnt out

Your going to need to do a hard reset, look at the manufactures site on how to do this

Page seven of a similar model manual http://www.spectraintl.com/images/stories/pdf/jn/UM/JCR-310_EIB.pdf 1. With the unit in Standby mode, press and hold the TIME SET button for about 1 second 2. Press the (two right triangle / two left triangle buttons) to adjust the hour. 3. When the correct hour is selected, press the TIME SET button to confirm and the "minute digits" will begin to flash on the display. 4. Press the (twwo right triangle/two left triangle buttons) to adjust the minutes. 5. When the correct minute is selected, press the TIME SET button again to complete the setting.

the code is 0123456

Hello,

the code is 012345 12345 or 0123456 or 123456

Good luck.

Plug it into the green input on component video. It should have the letter Y underneath it, meaning yellow

Take the batteries out of the remote and see if it still happens

Recommend you contact your nearest authorized service center directly or online here: Audiobahn Contact Church Sound Systems Audio Video Lighting Equipment...

Flooding which occurred three years ago could not possibly still affect speaker wires. Have you checked all the connections? Did any of the speakers themselves get wet? Still, if you want to get new speaker wire, just take a short piece from the existing wire to a good electronics place to make sure and match the impedence. They're not "called" anything except speaker wire.