The service repairman is here
Themostat... ? Some self cleaning ovens don't lock the door until the temp reaches near cleaning temperatures. If the termostat sensor is not sensing the high cleaning temperature the door will not lock
1/8/2018 2:25:15 AM •
Jenn-Air...
•
Answered
on Jan 08, 2018
I have a propane Jenn Air gas wall oven. The broiler works fine, the bottom log will not light because it isn't getting gas. The light to ignite the gas is working fine. What do I do? I do not hav
Hi I think that the Thermo-couple is bad That is the part that senses the flame or electric heat coil-heater warming up to ignite the flame for pilot light. there is a rod that is next to the electric coil which senses the heat coming from the coil. If that isn't working properly the pilot wont light and the log won't lite because the gas valve won't turn on for safety factors. The part is nit too hard to replace but you need to lay on the floor to get at it.
Sometimes the lower shield or bottom lifts up and removes
to service it . the thing is small about 1 in long with a copper tube, or steel braided jacket around the wire. the coil is maybe 6-10" long when rolled out. But don;t roll it out or bend a sharpkink in the thin copper tube because it will be ruined. The part doesn't cost much $10.00 -30.00. you may need some screwdrivers and 3/8 "or 7/16" open end wrench and maybe a 1/4 in. nut driver pliers..
Good luck, Bill
Oven not heating up
Is it a good coil ignition gas oven? If so. Try replacing that part. My guess is it isn't hearing up enough t9 fully open the burner
1/2/2018 2:11:17 PM •
Jenn-Air...
•
Answered
on Jan 02, 2018
We have replaced the relay board on a jenn-air
there is a big difference between an open circuit and a dead short
you will still get a reading indicating a circuit even with a dead short which is your code
suggest that you get in a technician to find the code faults as it is costing you money guess replacing
1/1/2018 3:07:03 AM •
Jenn-Air...
•
Answered
on Jan 01, 2018
I get failure code F9-3
What a scam by service personnel. -Simply press "Stop/Clear", then gently push the door handle until "Lock" appears on the screen. Press "Stop/Clear" again and the door unlocks itself!J. Kalicak
12/31/2017 6:39:14 PM •
Jenn-Air...
•
Answered
on Dec 31, 2017
Not finding what you are looking for?