Jeep Chrysler Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 10 Products
  • 43 Answers

Pandora Recovery Wizard has worked well for me when recovering deleted photo files. This following website describes the success of others.

1998 JEEP Grand... | 375 views | 0 helpful votes

Our RQ-8 will not tension up, believe the problem lies in the CL2 magnetic clutch.

1998 JEEP Grand... | 90 views | 0 helpful votes

try to find on ebay, normally you will

1998 JEEP Grand... | 84 views | 0 helpful votes

you can get a chilton manual for a jeep at advance

1998 JEEP Grand... | 68 views | 0 helpful votes

Could it be on the ring gear at the back of the engine or on one of the cams if using a timing belt . Could be under a rubber plug on the top of the timing gear covers .

1998 JEEP Grand... | 91 views | 0 helpful votes

If you can lock the cams from turning you won't have to worry about where the crank is situated as there is always a cam lobe that is loaded that will turn the cam just a bit when you take the belt off . The thing that I had done when replacing the timing belt on my ridgeline was to mark the timing belt at a gear tooth for each gear and put a location mark at each mark ( ie CR for crank ) . Then once I had the belt off I transferred the marks to the new belt and put the new belt on aligning the marks to the proper sprockets . The problem that I had was I didn't think about the cam rotating as I took the belt off . But luckily it was only one cam that had moved so I just had to put a socket on the nut and rotate it to where the mark lined up .

1998 JEEP Grand... | 87 views | 0 helpful votes

order from dealer or parts store..

1998 JEEP Grand... | 133 views | 0 helpful votes

To get them, Just press "Services" on your Sky remote, and then pick "System Setup", then "Add Channels", and then key in the info below

1998 JEEP Grand... | 74 views | 0 helpful votes

e bay

1998 JEEP Grand... | 139 views | 0 helpful votes

Common problem with worn starter motor brushes, if your battery is good though!

1998 JEEP Grand... | 101 views | 0 helpful votes

first check there is oil in the gearbox at the right level
second pull back the rubber boot and look for foreign matter interfering with the gear changer or cabling ie twigs branches and dont laugh rodents! ie those who seek out warm places like exhaust pipes

liberally spray some grease or oil over the linkage under the gearchange boot and see if was just dry metal on metal

1998 JEEP Grand... | 132 views | 0 helpful votes

check for correct oil level in the gearbox
check for foreign matter in the gearchange linkages
ie twigs branches road debris mice
you might have to lift the rubber boot around the gear lever
and then add some spray grease or oil on the linkage under the boot

1998 JEEP Grand... | 135 views | 0 helpful votes

More than likely the battery is your problem here, I have had this issue before with my mazda bakkie, ended up being a dead cell in my battery, changed the battery and problem was solved.

1998 JEEP Grand... | 71 views | 0 helpful votes

With the hood open,look at the top of the light there should be a screw that goes down through an ear of the turn sig/mark unit. Take that out-then pry the unit off the truck between the fender and the lamp unit-Cheers-Denny

1998 JEEP Grand... | 50 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Jeep Chrysler Experts

Les Evick

Level 1 Expert

7 Answers

Jim W.

Level 1 Expert

12 Answers


Level 2 Expert

39 Answers

Are you a Jeep Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides