Jeep Vehicle Parts & Accessories - Popular Questions, Answers, Tips & Manuals


Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Jeep Vehicle... | 100 views | 0 helpful votes


PO351 means Ignition coil A Primary/ Secondary circuit malfunction.

Ignition System... | 234 views | 0 helpful votes


i did had the same problem on my chevy van
the problem was the wrong light bulb ,,
check if you have power in the sucket with a tester
if you do, buy new light bulbs make sure you get
the right ones ,, i did that n fix my problem ,, good
luck...

99-02 Dodge... | 68 views | 1 helpful votes


tcm is probably fine, use a scan tool to read sensor data, and determine the cause of the faults.

Transmission &... | 152 views | 0 helpful votes


Thank you! This is the best. See on the attached circuit diagram
25250856-zahxm3enxjfreiqe1zvag1pl-2-0.jpg Listings for Brake Repairs 231

Computer, Chip,... | 69 views | 0 helpful votes


Problem with Air intake.. probably air filter needs to be replaced...

Transmission &... | 39 views | 0 helpful votes


The accessory drive belt is a serpentine type belt that is driven by the crankshaft pulley
The belt drives the A/C compressor , alternator , power steering pump and water pump . Belt tension is maintained by an automatic belt tensioner .
Removal:
1. Using a wrench, rotate accessory drive belt tensioner counterclockwise until accessory drive belt can be removed from pulleys .
2. Remove accessory drive belt .
Installation:
NOTE: When installing drive belt on the pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulley grooves.
1. Install the accessory drive belt around all the pulleys except for the alternator pulley.
2. Using a wrench, rotate accessory drive belt tensioner counterclockwise until accessory drive belt can be installed on the alternator pulley .Release spring tension onto accessory drive belt .

COMPASS 2008... | 178 views | 0 helpful votes


The most common reason is that the break peddle is not press or not pressed in far enough.

Transmission &... | 38 views | 0 helpful votes


there is no dipstick filler plug on side of tranny

Transmission &... | 36 views | 0 helpful votes


Rubber drain hose from condenser is kinked or plugged. May even be disconnected. It runs through the firewall to outside for draining.

Air Conditioning... | 56 views | 0 helpful votes


If it is shifting through all the gears manually then you have bad Shift Solenoid. Its pretty simple to change out once you drop the pan you can see it.

Transmission &... | 85 views | 0 helpful votes


Hello it should be located on passengers side under hood on the fire wall behind coolant tank.

Jeep Vehicle... | 41 views | 0 helpful votes


Passenger side on the firewall..

Jeep Vehicle... | 24 views | 0 helpful votes


This could be many different things if you recently had new break pads installed I would first start there. Check and make sure that they were installed correctly and the caliper pistons are pushing against them correctly if they are a little crooked then the piston may not be making proper contact and causing your problem next I would check the master cylinder and make sure it is working properly If you have not recently had any break work done I would say your master cylinder is going out.

Brakes for Jeep... | 78 views | 0 helpful votes


do you notice this when your going up hills too? like it blows hot air if you have it on but if your not goin up hill it doesnt? i had the same thing when the gas pedal was down the heat would work and had to replace the reservoir for the coolant or something else check your coolant level too...just remember some cars run with different colored coolants than others

Jeep Vehicle... | 59 views | 1 helpful votes


The climate control where you control the tempature in the dash is bad cheapest way to fix this is order a new one online its as simple as pulling the screws out of the old one and unhooking the plug out of the back and plugging the new one in.

Air Conditioning... | 95 views | 0 helpful votes


make a video of the issue

Jeep Vehicle... | 21 views | 0 helpful votes


Is this the cooling line going to the radiator?
Before this, did the transmission shift hard when first putting it into gear or while it was shifting?

Jeep Vehicle... | 24 views | 0 helpful votes

Not finding what you are looking for?
Jeep Logo

47 questions posted

Ask a Question

Usually answered in minutes!

Top Jeep Vehicle Parts & Accessories Experts

Philip Armitage

Level 3 Expert

437 Answers

Andrew Gaitan

Level 1 Expert

28 Answers

Dirtydog

Level 2 Expert

194 Answers

Are you a Jeep Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...