JCPenney Popular Questions, Answers, Tips & Manuals

Recharge IT!
On a full charge the normal flying time is 6 to 10 minutes.

You can call Products America at 800-205-9642 or 800-772-1041. We offer a wide verity of hardware and instructions for many cribs.

Contact Products America. We may be able to help you. [email protected] or 800-205-9642

You can call Products America at 800-205-9642 or 800-772-1041. We offer a wide verity of hardware and instructions for many cribs. Our qualified customer service staff is standing by to help you with proper selection, pricing and ordering information. We are open M-F 8am to 6pm CST. We look forward to speaking with you!

Normaly you have at each piece of the bracelet to the side a little pin and if you push it troug you can get one piece away then you put te pins back in and you fixed it.

doubld blade rotor there is no need for a rear/tail rotor, on the remote are 2 buttons they will control Left/Right spin , adjust so that it does not spin around

buy a new one

I solved this same problem by removing the canopy and realigning the helix shaft with the motor gear. The small screwdriver provided will work. Be careful of the front white LED light when pulling the canopy off.

You havent given us enough detail. When you say 'Bottom Spring" do you mean the mattress support?
The drop down bars bolt on to the headboard or footboard (one each) and let the dropside move up and down, held in place by the bars. The backside usually has bolts that run thru the head and footboard
to attach them. Some just have small nubs that the top of the backside sit onto and a bolt holds the
bottom of both sides. If you wish to send a picture of what you have for further details, send
it to [email protected]
I will help you get it right.

check the manufacturer website and order instructions online.they may even have a way to print them out directly .good luck

Regularly check the website of the Consumer Product Safety Commission for list of recalled baby products and sleep sets.

You can also check out http://www.cbsnews.com/8301-504763_162-20008769-10391704.html. The list changes every year so you have to find out if the brand of crib you are looking or is included in the list.

Source: http://www.bestmattressreviews.com

We need Make/name, model number and Date of manufacture (MFG).
Please repost a new question with this info and we will do our best to get it for you.

will not fly

try to play around with the trimmer.. i had the same problem but then guessed it was the trimmer and iwas right!

Yes if the rear propeller does not work the helicopter cannot be made to turn around. So it is important that the rear rotor works.
Now make sure that the drive is working to let the motor work , if controlled by the remote make sure the remote command works or is a fault in the remote.
Check the mechanics of the rotor movement. reset.

I have the same problem with a desktop clock. you just have to get used to it that way it's designed to run in certain time zones

The only way to find out if your crib has been recalled is to find out what kind of crib you have. Here is a link to an article about the recent drop side crib recall. ARTICLE

Push the mode button until you get to the AL function (alarm). On the right hand side of the dial where you would normally see the seconds go by in the small round bezel, you will see a "--" or a "-1" or "-2" etc., these are the individual alarm programs. Cycle through them with the EL button and turn off/on the individual alarms with the ST/SP button as needed.

definetly a short circuit some were in the copter itself

There pretty good about returning those items they can be a lot of fun good luck james

Unknown ? very hard to say since that telescope is an imported model that really no one uses for astrophotography.