Need a replacement bracket
You will not find one. Drop sided cribs have been pulled from the shelves and are now illegal to sell, or support with accessories because they break and the drop sides have killed children. You need a new crib. Sorry.
Gyropter not lifting off after full charge
Hi, Mostly all the micro copters problem are the battery and the the pinion gear that's been worn out.Check both of these part. Battery should at least gives out 350 mili amp. and the gear should touch the propeller shaft gear at the bottom of the copter.Get a lithium ion battery for more power and longetivity.Hope that helps!
11/20/2011 1:31:16 PM •
JCPenney...
•
3,419 views • 0 helpful votes
Need help putting together
We may be able to assist you. Please call us at 800-205-9642 or 800-772-1041 or email
[email protected]. One of our knowledgeable customer service reps will be happy to assist you with your replacement hardware.
Chopper spins clockwise . How do I fix it
It is spinning around because one of the rotors is not spinning at full speed. This happens when you bump a spinning rotor against something. Determine which one it is by observation or logic (i.e, the one that turns clockwise will produce counterclockwise torque, which is to be balanced by the other rotor spinning counter clockwise. So the counter clockwise spinning rotor is slow) Tighten the screw that holds that rotor that is spinning more slowly. Use the screwdriver that came with the spare parts.
12/15/2011 1:14:45 AM •
JCPenney...
•
1,087 views • 4 helpful votes
The gyropter will not charge
Hi,
Check the charger adaptor if it has any output power. If no power comes out replace the adaptor.
Check also the battery terminal, it might already corrode and needs clean up.
If all does not work, the battery in the helicopter is already malfunctioning.
hope that helps you out!
8/14/2011 5:29:32 PM •
JCPenney...
•
7,503 views • 3 helpful votes
I have a rockland cottage
I know of a website called mySimon.com that carries rockland prouducts and parts. If that does not work maybe a look on craigslist or ebay to find the part you need, and maybe the person selling the item will break the crib down. i would also try rocklandmfg.com. I hope that helps you because this can be a problem.
9/17/2011 3:27:45 PM •
JCPenney...
•
334 views • 0 helpful votes
Fully charged the choppers battery,the
The light will keep flashing unless you are on the correct channel A B or C and you hit the "Light" button on the front of the unit.
As far as the high speed take offs I suggest identifying which A B or C setting is correct for your copter. In order to do this turn off the RC controller. Set the Selector switch to "A" move the left joystick "throttle" half way up and then turn on the power. Assuming that the copter is still ON it will either fire up or do nothing. If it does nothing try the same sequence with the selector switch set to "B" and try again. If nothing try "C".
Now, as far as the rapid accelleration, I read one online comment that indicated that there is some type of "programming" sequence that the unit learns by pushing the left joystick throttle all the way forward and then back to zero when you start to fly it. So after the first "blast off" set the copter back down or even hold it in you hand by grasping the the landing runners and move the throttle forward until the rotor spin up and it lifts off. In your hand it is easier to keep it from going up too quickly.
Good luck!
8/21/2011 2:04:33 PM •
JCPenney...
•
618 views • 0 helpful votes
The Clasp broke on My
I don't know the details of the guarantee for your watch but most makers exclude anything that is not inside the case, e.g. strap, crystal or anything else that you are likely to damage and want repairing!
I suggest you contact Elgin and see if they can sell yo another strap.
I need replacement parts to
You can call Products America at 800-205-9642 or 800-772-1041. We offer a wide verity of hardware and instructions for many cribs. Our qualified customer service staff is standing by to help you with proper selection, pricing and ordering information. We are open M-F 8am to 6pm CST. We look forward to speaking with you!
Not finding what you are looking for?