Jayco Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 288 Products
  • 56 Answers
  • 13K Views
0helpful
1answer

Every time i put a 15amp fuse in it blows it whats wrong

You will have to find the short circuit some place in the wiring. The first thing to do is trace the circuit to find the short. You have to locate the item that the circuit controls and determine if that is where the short is. Disconnect what ever it powers and see if the fuse still blows if it does now blow with that item disconnected you have found the problem. If it still blows it is in the wiring some place.
11/8/2014 5:52:45 AM • Jayco 2013 Jay... • Answered on Nov 08, 2014
0helpful
1answer

Help me locate a leak in the bathroom

need to check connections going to shower. turn on water and see if runs down lines. also try to reach up to the sink connections a do the same. they tend to come loose. should be able to hand tighten. also check behind toilet at connection.
10/14/2014 8:41:07 PM • Jayco 2011... • Answered on Oct 14, 2014
0helpful
1answer

What lies behind panel in storage compartment backing up to where the stairs inside lead to bedroom?

Probably your converter, which also charges battery when plugged in.
9/6/2014 6:14:22 AM • Jayco 2009 Eagle... • Answered on Sep 06, 2014
0helpful
1answer

Any one have a wiring diagram for the holding tanks. the wires for the grey and black water are all broken off

Usually white will be the ground going to the lowest and usually a little more distance from others. Then simply get someone to push levels button on monitor and as you touch each wire separately to white wire or screw head it is attached to, the corresponding light at panel will tell you which is which.
9/3/2014 7:22:45 AM • Jayco 2013 Jay... • Answered on Sep 03, 2014
0helpful
1answer

Jayco wiring diagram

Look for a GFCI receptacle in area and try pushing reset button .
8/3/2014 9:55:16 PM • Jayco 2013 White... • Answered on Aug 03, 2014
0helpful
1answer

Why does the main double 50amp breaker arc real bad and then trip out?

Over loading the system or a dead short,check all wireing.
7/26/2014 5:22:49 AM • Jayco 2014 Jay... • Answered on Jul 26, 2014
0helpful
1answer

Drain valve for fresh water tank

There should be three low point drains located under the trailer. Two will be close, side by side, to one another. This is the low point for the entire plumbing system, both cold and hot. There will be another single low point drain which will be for the fresh water tank. The low point drains may only have a cap on them or may have a valve installed.

7/25/2014 7:57:18 AM • Jayco Eagle 33.5... • Answered on Jul 25, 2014
0helpful
1answer

Dead bolt is not lining up

Adjust striker plate on door jamb.
7/24/2014 8:17:35 PM • Jayco 2013 Jay... • Answered on Jul 24, 2014
0helpful
1answer

How do you de-winterize 28DSBH

Connect the trailer to the city water supply, turn on the water and open each faucet until clean clear water is present. Don't forget the toilet and outside shower if equipped. Next reinstall the anode rod (suburban) or drain plug (atwood) into the water heater. Go to the back side of the water heater and close the valve on the pipe that connects the cold (bottom line into water heater) and hot (upper line out of the water heater) and then open the bottom cold water line valve and, if equipped, the upper hot water valve. This will fill the water heater. Open the hot water valve at the kitchen faucet. When the water flow is steady the water heater is full and ready for use. If the unit is equipped with a water filer, after all is flushed out, turn the water off and remove the filter housing. Install a new filter and re-secure the housing and turn the water back on. If you are using the fresh water pump, it is possible that the winterizing valve for the pump was left open. If so, close that valve which will divert the pump back to drawing from the tank.
7/24/2014 5:39:54 PM • Jayco 2013 White... • Answered on Jul 24, 2014
0helpful
1answer

How do i get the tv to work

Will it not come on at all or are you not getting reception? If it will not come on you must first determine if you have electrical power at the outlet. If not, resolve the problem with the loss of power. If you do have power, check the tv for possible internal failure. If it is a reception power there are a lot of variables to take into consideration. Is the antenna in the raised position, is turned in the right direction, is it designed to receive digital signal, is the TV designed to receive digital signal, is the booster turned on... and so much more.
7/24/2014 5:23:37 PM • Jayco 2009... • Answered on Jul 24, 2014
0helpful
1answer

Can't get water to come into my TT

The check valve should not be removed from the housing. You would have to remove the actual entire city water connection to gain access to the water line connection behind the water fill. The check valve must be there to prevent water from being pumped out of the fresh water tank should you be utilizing the demand pump. Before you go through all of that hassle. Remove the aerator from the kitchen sink and turn on the faucet to check the water flow. I have seen the aerators clog up and stop all water flow. When you remove the aerator disassemble and you will notice a small white disc with a tiny hole in the center. Pop this disc out and discard. Reassemble the aerator and reinstall. Also, if you are using a pressure regulator by pass it to see if water flow is restored. Those can fail as well.
7/23/2014 9:15:52 PM • Jayco 2011 Eagle... • Answered on Jul 23, 2014
0helpful
1answer

Where can i downoad jayco user manual

Contact the manufacturer of the coach for their owner's manual. However, each appliance will have a separate owner's manual form its perspective manufacturer, i.e., Water Heater = Suburban, A/C = Dometic, Refrigerator = Norcold, etc.. There will not be a diagram of electrical or plumbing as a majority of the RV manufacturers do not publish that information.

7/23/2014 9:02:35 PM • Jayco 2014... • Answered on Jul 23, 2014
0helpful
1answer

2010 jay feather ext 213 slide switch problem

What is the problem that you are experiencing?
7/22/2014 12:12:36 AM • Jayco 2008 Jay... • Answered on Jul 22, 2014
0helpful
1answer

I need a wiring diagram?

goto jayco.com and enter your model number to d/l a manual for it. also you need too goto wemakeitsafer.com there a a few recalls regarding the wiring on your model and other jaycos. seems they wire things with thee wrong polarity
6/21/2014 11:56:38 PM • Jayco 2013 Jay... • Answered on Jun 21, 2014
0helpful
1answer

Does any one have a wiring diagram?

goto jayco.com/tools/archives. enter model number and you can d/l a pdf of manual. the wiring is probably backwards. deepending on what you are having a problem with. also goto wemakeitsafer.com that website shows all the recalls for this particular model. there are a few regarding wiring.
6/21/2014 11:54:13 PM • Jayco 2013 Jay... • Answered on Jun 21, 2014
0helpful
1answer

De-winterizing RV (2011 Jayco 29 QBH) when hit the battery pump switch, water shoots out city water connection.

Remove the screen/washer at the city valve and you see a small stem in center of valve, that's the plunger (check valve ) . Use a pair of needle-nose pliers if necessary to push it in ( it should have spring behind it) slightly and make sure it is centered in the hole, then just pull on it slightly to seat it. Now try pump. If it won't seat properly and water still shoots out, it's probably defective and needs changing. Perhaps whoever winterized it forgot to push that in after pumping antifreeze through system, which results in water trapped in valve, thus freezes and breaks apart inside. If your stuck, screw a plug the right size into the city water fitting. Short piece of old garden hose with male end & plug (old bolt or anything proper diameter) and small hose clamp in other end will work for temporary use even.
4/19/2014 9:51:31 AM • Jayco Jay Flight... • Answered on Apr 19, 2014
0helpful
2answers

Battery/elecrtic

You might unhook the battery and with the camper plugged in to shore power the 12v lights should work. If not check the breaker that goes to the inverter. If that is not tripped then check the power output at the converter. I would expect the inverter is shot. I replaced the one on my Jaco two years ago with (Progressive Dynamics 60 Amp Power Converter with Charge Wizard and the remote pendant)
4/17/2014 2:01:19 AM • Jayco 2010 Jay... • Answered on Apr 17, 2014
0helpful
1answer

I have to keep battery charger pluged in or nothing works

Probably one of the cell might not be working properly ie not holding the charge hence battery getting flat. Or check liquid level in the battery, might be low. or time to change.
2/11/2014 6:31:57 PM • Jayco 2010 Jay... • Answered on Feb 11, 2014
0helpful
1answer

Adjusting slide on a 2013 greyhawk 29 ks

U may watch this guide http://www.youtube.com/watch?v=YwYPvzZAVlM,Cheers hope u already solved the prob let the others know.
10/27/2013 10:15:11 AM • Jayco 2013... • Answered on Oct 27, 2013
Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Jayco Experts

Renee Knafel-Bullock

Level 3 Expert

404 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

David Spradling
David Spradling

Level 3 Expert

13524 Answers

Are you a Jayco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...