Can I download embroidery editor from janome site instead of downloading from cd
You can download the Artistic Designer program from Janome,
https://www.janome.com/products/software/ . However, it will not work unless you have purchased a license key from a dealer. For other Janome software, only updates for supported software are available:
https://www.janome.com/support/general-support/software-support/ . You'll either need the program to have been installed on your computer or to put the CD in an optical disc drive. If your current computer doesn't have an optical disc drive, you can get a USB optical drive from Amazon or any other shop that has electronic/computer parts. USB DVD read/write drives are under $50 even at most shops that don't discount accessories. You may need the USB type C (M) to USB type A (female) adapter with some of the newest models (laptops and tablets).
I hope this helps. Please add a comment with the name and version of your software for further assistance. If your software is no longer supported by Janome, there are some third-party embroidery editing software packages. One is
https://www.embird.net/ .
Cindy Wells
I have a Janome Skyline 9 sewing machine. The flywheel will not move and I get an error message that begins " Warning! Is something stuck in the machine? Is the cloth too thick?"
Try taking the bobbin out and see if the machine will turn by hand movements using the flywheel or running the motor, you will feel and resistance if there is any but do not force the machine! if the machine turns without getting stuck then try a different bobbin as this might indicate a problem with the bobbin. I am also assuming you have placed the bobbin facing the correct way meaning the thread which is an easy mistake to make. Next, try eliminating different parts of the machine like turning it on different settings or without a needle, open the front part of the machine where you would normally replace the light bulb and watch as you hand turn the machine for any knocks or places of resistance, also unscrew the very backplate at the flywheel as the machine is usually connected by a rubber belt going from the motor to the machine and check that it is not caught up or broken. On older machines that did not have an onboard computer made it more easy to solve problems because if there is a problem the machine wouldn't just shut down, So elimination should solve the issues.
Janome 6260 after running for about 1 hour will start to sew erratically, then stall with LO message. Will not wind bobbin when this message is displayed. Bobbins wind loosely and unevenly.
Here's Janome LO error;
LO: Replace the foot controller.
- Check for a tight or stuck clutch by the hand wheel.
- The machine may be jammed. Remove the timing belt to locate whether the bind is on the upper shaft or lower shaft. If it is the upper shaft, there may be thread caught in the take-up lever or crank pin. If the lower shaft is binding, check hook clearance, hook backlash. Check the lower shaft rear bushing for any black 'gunk'. If there is, replace the lower shaft and rear bushing.
- Clean the sensor on the DC motor and check if the shield plate on the motor is not loose or hitting the sensor. If either the sensor or shield plate is damaged, replace the motor.
- Check the upper shaft sensor. Make sure the shield plate is going perfectly thru the middle of the sensor. Replace the sensor and/or shield plate if damaged.
- If you still get the error, replace the DC Motor or upper shaft sensor (in this order).
My first thought is if you're running nearly non-stop for an hour the motor is overheating. Not sure what the maintenance schedule is for this machine <?>. May need a good cleaning/lube. Then foot pedal, then other.
How do I put my Janome 7330 in free motion sewing,?
"The Freemotion Quilting feet are available in two styles; Open Toe and Closed Toe. Open Toe Foot for general use and extra visibility, and the Closed Toe Foot for general use with lace and catchable fabrics. The feet are available for high shank and low shank machines.'
Not finding what you are looking for?