Jandy Popular Questions, Answers, Tips & Manuals

push button below auto service and time out 1 time to put it in auto

Does your pool gave an attached spa?

IF it does have a spa, dies it also have a spa side remote?
If so the first step would be to unplug the spa side remote from the back of the board.
If the issue stops then you need a new spa side remote if it persists then it nah be be main circuit board or relay for the heat pump.

A pool will over flow in the rain, the pool pump is only for circulating water not for draining overflow , you can go to a local pool supply and buy a pump to hook to a garden hose and drain it partially, be aware that the pump runs on electric power and you want to be careful not to drain the pool below the skimmer level or you will end up replacing the pool pump motor

Bob, sounds like it is working as designed. If the temp indicates 97, of course it won't fire if you set 84 as the temp (97) is already above that. When you set 100, it is higher than 97 and the unit attempts to raise the temp those 3 degrees. If you don't think the water is already at 97, then there is a calibration problem with the temp sensor.

go into system setup then find time and date reset to correct if every time the power goes out it is wrong you need to replace the battery backup either a 9 volt or a nicad on back of PCB board

high speed is an aux and low speed should be another aux if to run all day designated program to each aux

go into system setup to lights pick yours enter and turn aqualink off then back on they should work

Jandy Laars Lite2 Hot Surface Igniter Replacement Laars Lite2 LJ Heaters 2003 Present Pg 1

go into the setup you can change the backlight options there

You have to go into the programming and "Enable" the Settings for Solar Operation.

try turning off aqualink then turning back on then the PDA if still same check in the front case make sure 4 pin red connector is connected and tight make sure the wire going to the antenna isnt cut

The water temp sensor needs to be replaced with a new 10k temp sensor. To find your sensor, follow the plumbing from the top of your filter pump, until you see a hose clamp, under the hose clamp is your temp sensor

hit cancel after that shows up for each program that will get rid of them or you can write down all the information then hit clear memory and reprogram all you auxs

your aqualink has a one touch chip in it you have to program with the hard wired controller if you dont have one you need to upgrade the chip to a PDA chip to program with the hand held

make sure the wiring is correct then take fenwall off turn around to see if burned spot where ignitor wires go in sometimes the ignitor will take out the fenwall shorting it out so you will keep going through ignitors

the PDA screen has been hit against something you need a new PDA try to get one on line try amazon

check the AP radio frecuency and channel, mey be the antenna is not compatible

m setup then go to go toPDA options and change back light

power aqualink system down all breakers turn off PDA then thurn aqualink back on then PDA should work if not need more info

make sure filters are clean check to see if voltage on both sides of pressure switch and both sides of fuseable link also make sure proper gas pressure at unit when turning on does fan come on? does ignitor glow also check all fuses