Jandy Popular Questions, Answers, Tips & Manuals

Buy your self two new sensors, they are both the same. If your system if reading sensor open when disconnected from the board then your new sensors should do the trick.

Need a new controller. May be cheaper to upgrade to IAquaLink and control through a smart device with the app

Your unit is more than likely going into Defrost mode. The defrost sensor is mounted to the coil, should be down low on the right. You should get a new sensor and replace it. You have already replaced the board so the sensor is either bad or you may have another issue. If the fan is not operation properly you are not getting proper air flow thru the coil, the coil can then freeze. If you are operating the heater in very cold weather it could freeze. If your coil is not clean and air can not flow thru the coil it will freeze.

What’s the issue your having. More info the better and pics help also

Low refrigerant or a bad sensor. Need a pro to look at it.

It sounds like low gas pressure.

start on page 17. this should be done by electrician. pump is 230 vac and there must b a different wiring to use 120 vac. Call an electrician, and stop replacing igniters. https://www.jandy.com/~/media/zodiac/global/downloads/h/h0248900.pdf

Check tour manual https://www.masterspas.com/hot-tub-owners-manuals/

Contact a dealer for repair. http://www.oceanspringstech.com/ https://www.zodiac.com/en/united-states/...

After it removes all the air it will probably just look clear. I don't think you have a problem there if water is running into skimmer and coming out of return jets.

Check your salt level in pool. Also make sure that the wires going in to the cell are making good connection.

Turning off the power and then back on will do a simple reset. Resetting your jandy will probably not fix your issue. The issue seems more like a bad relay or bad pump or the breaker for the pump may be tripped.

Have you tried using the three way toggle switch on the JVA? It might be in the locked position. If the JVA is not working you can always move the valve manually until you replace it. First, put the directional toggle switch in the locked (center) position. Second, loosen the retaining screw on top of the JVA handle about half way to three quarter out. Third, push down on retaining screw firmly to disengage JVA. Fourth, while pushing firmly on retaining screw rotate valve manually with handle to desired position.

Check salt, how old is the system?

What model and for how long does it stop working and what do you do to get it to start working again?

Look up Zodiac Pool systems, on the web site you can find a list of service providers in your area. You may be looking at replacing your automation at this point.

The 6613 is a power center. You will need an RS system or an automation control that is compatible with the IAqua Link system, connected to your Wi-Fi.

Sounds like you have an LJ Laars heater. The heater is old and it is very likely that the board is having trouble reading the sensor. All the boards are very expensive, might not be worth saving the heater. You may end up replacing more than one board. The sensor should be tested before changing the power control board, R0366800.

I assume you have an RS4-PS. I would check the filter to make sure it is clean. If you have a dual equipment set up then call a Jandy automation expert.

Sounds like an air leak in the system. If you have a media filter make sure that the back wash line is not leaking or look for leaks in plumbing.